4 Brush the inside of the shaving unit (Fig. 9).Service Department of Philips Domestic Appliances and
english
Personal Care BV.
5 Brush the hair chamber (Fig. 10).
important 6 Put the shaving unit back onto the shaver.Troubleshooting
Read this user manual carefully before you use the ProblemSolution
every two months: shaving heads
appliance and save it for future reference.
The shaver You may not have cleaned the
Warningdoesnt shave appliance properly. Clean the shaving
-This appliance is not intended for use by persons Note: Do not use cleaning agents or alcohol to clean the
shaving heads. Only use the HQ110 Shaving Head Cleaning as well as it heads thoroughly (see chapter
(including children) with reduced physical, sensory used to.Cleaning and maintenance).
Spray.
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision 1 Switch off the shaver.Long hairs may be obstructing the
or instruction concerning use of the appliance by a 2 Remove the shaving unit (Fig. 8).shaving heads. Clean the cutters
person responsible for their safety.and guards properly with the brush
-Children should be supervised to ensure that they 3 Turn the wheel anticlockwise (1) and remove the supplied (see chapter Cleaning and
do not play with the appliance.retaining frame (2) (Fig. 11).maintenance).
Caution 4 Remove the shaving heads from the shaving unit The shaving heads may be damaged
-Use and store the appliance at a temperature one by one (Fig. 12).or worn. Replace the shaving heads
between 5C and 35C. (see chapter Replacement).
-This shaver is not waterproof and cannot be cleaned Note: Do not clean more than one cutter and guard at a The batteries may be running low.
under the tap. Keep the shaver dry (Fig. 1).time, since they are all matching sets. If you accidentally mix Replace the batteries (see chapter
-Remove the batteries from the appliance if you are up the cutters and guards, it may take several weeks before Preparing for use).
not going to use it for quite some time.optimal shaving performance is restored.
The The batteries may be empty. Replace
Compliance with standards 5 Remove the cutter from the guard (Fig. 13).
shaver doesnt the batteries (see chapter Preparing
-This Philips appliance complies with all standards switch on for use).
6 Clean the cutter with the short-bristled side of the
regarding electromagnetic elds (EMF). If handled brush (Fig. 14).when I push
properly and according to the instructions in this the on/off slide
user manual, the appliance is safe to use based on 7 Brush the guard (Fig. 15).
upwards.
scientic evidence available today.
8 Put the shaving heads back into the shaving unit. You may have inserted the
Preparing for usebatteries incorrectly. Insert the
9 Put the retaining frame back into the shaving unit
The appliance runs on two R6 AA 1.5-volt alkaline and turn the wheel clockwise.batteries correctly into the battery
batteries. We strongly advise you to use Philips Powerlife compartment. Make sure the + and
10 Put the shaving unit back onto the shaver.
batteries. - poles point in the right direction.
They supply sufcient ener gy for up to
60 minutes of shaving.Tip: For optimal shaving performance, we advise you to
lubricate the shaving heads with a drop of sewing machine
inserting batteriesoil every six months.
storage
1 Remove the lid of the battery compartment (Fig. 2).
-Put the protection cap on the shaver after use to
2 Put two batteries in the battery
prevent damage to the shaving heads (Fig. 6).
compartment (Fig. 3).
Replacement
Make sure your hands and the appliance are dry when
you insert the batteries.Replace the shaving heads every two years for optimal
shaving results.
, Make sure the + and - poles of the batteries point
Replace damaged or worn shaving heads with HQ4+
in the right direction
Philips Micro+ Lift & Cut Shaving Heads.
Note: The appliance does not work if the batteries have 1 Switch off the shaver.
been placed incorrectly.
2 Remove the shaving unit (Fig. 8).
3 Put the lid of the battery compartment back onto
3 Turn the wheel anticlockwise (1) and remove the
the appliance (click).
retaining frame (2) (Fig. 11).
Avoiding damage due to battery 4 Remove the shaving heads from the shaving unit
leakageand replace them with new ones (Fig. 12).
-Remove the batteries if you are not going to use the
5 Put the retaining frame back into the shaving unit
appliance for a month or more.
and turn the wheel clockwise.
-Do not leave empty batteries in the appliance.
6 Put the shaving unit back onto the shaver.
Using the appliance
Accessories
1 Remove the protection cap.
The following accessories are available:
2 Push the on/off slide upwards to switch on the
shaver (Fig. 4).-HQ4+ Philips Micro+ Lift & Cut Shaving Heads
-HQ110 Philips Shaving Head Cleaning Spray (not
3 Move the shaving heads quickly over your skin. available in some countries)
Make both straight and circular movements (Fig. 5).
environment
Note: Shaving on a dry face gives the best results.-Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in
Note: Your skin may need 2 or 3 weeks to get accustomed to at an ofcial collection point for recycling. By doing
the Philips shaving system.this, you help to preserve the environment (Fig. 16).
-Batteries contain substances that may pollute
4 Push the on/off slide downwards to switch off the the environment. Do not throw away empty
shaver.
batteries with the normal household waste, but
5 Put the protection cap on the shaver to prevent dispose of them at an ofcial collection point for
damage to the shaving heads (Fig. 6).batteries. Always remove the batteries before you
discard and hand in the appliance at an ofcial
Cleaning and maintenancecollection point.
Regular cleaning guarantees better shaving performance.
guarantee & service
every week: shaving unit and hair chamber
If you need information or if you have a problem, please
visit the Philips website at www.philips.com or contact
1 Switch off the shaver.
the Philips Customer Care Centre in your country
2 Brush the outside of the shaving unit with the (you nd its phone number in the worldwide guarantee
brush supplied (Fig. 7).leaet). If there is no Customer Care Centre in your
country, go to your local Philips dealer or contact the
3 Remove the shaving unit (Fig. 8).
4222.002.4835.1
2/9 |
ACEC
