20ENGLISHENGLISH21
Preparing Jet Clean System For Use1 PlacetheJet Clean Systemonaflat,level
surface.
Important
� Only use the razor,power plug,Jet Clean SystemC2 Simultaneously press the buttons located
and HQ200 cleaning solution provided toon both sides of the Jet Clean System (1)
charge or clean razor.and lift the appliance off the Jet Clean
� Only use a Philips Norelco �XLCCO model canister (2).
razor with the Jet Clean System.Always remove appliance from canister by lifting
� Other Philips Norelco�XO,�XLO or�LCO modelstraight up. Do not tilt Jet Clean System.
razors DO NOT work with a Jet Clean System.
� Empty the cleaning solution canister and 3UnscrewthelidontheJetCleanSolution
thoroughly rinse the canister clean with warm bottle (Model HQ200) provided with the
water every 2 weeks.razor. Remove the airtight seal by lifting up
� The Jet Clean System thoroughly cleans but the tabs on the seal. Replace lid on the bottle
does not disinfect your razor, therefore, do notmaking sure the lid is screwed on securely.
share razor with others.
� Thecharging plug converts 100-240VAC toC4OpenlidandpourtheJetCleanSolutioninto
less than 24V DC.the canister up to the MAX indication
� Place the Jet Clean System on a flat, stablelocated inside the canister.
surface to avoid any leakage. Be careful not to tip
or move the Jet Clean System if it is filled with NOTE: ONLY USE PHILIPS NORELCO JET
the cleaning solution.CLEAN SOLUTION (MODEL HQ200)WITH
� To avoid evaporation, do not expose cleaning THE JET CLEAN SYSTEM. ANY OTHER
solution to direct sunlight.SOLUTION MAY CAUSE DAMAGE TO YOUR
� Remove the protective razor head cap from RAZOR.
the razor before charging or cleaning the razor
in the Jet Clean System.
� Use this appliance for its intended household
use as described in this manual. |
ACEC
