SETTINGTHE REMOTE TO WORK OTHER DEVICES - SEARCH
SEARCH METHOD
our TV remote can be set to
Ywork various accessory
SATELLITE RECEIVER
devices (VCRs, Cable Converters,
Satellite Receivers) by what is
called the SEARCH method.
06
Note: The Search Method only
07
works with devices equipped with
CABLE TV08
Channel DisplayIndicators orCONVERTER06
capability. If the "Direct Access"0709
code number method (shown in081
the previous section) did not set
your remote to work your acces-0906
sory device, then follow the easyVCR07
steps listed below.
08
BEGIN
09
1Turn ON the desired device.
Don't let the Accessory Device
Press the correct VCR or ACC
scan up more than five channels
system button on the remote.(in Search mode).
Six Feet
(minimum)
2Stand at least six feet away
from the front of the accessory
device. Point the remotetoward
3
the unit. HOLD DOWN the
SURF and the desired System
(VCR or ACC) buttons at the
same time. KEEP HOLDING
REC lPLAY?STATUS
BUTTONS DOWN.CLEAR
MENU
REW!M~FF
3Watchthe Channel Indicator§§??
on the unit. Channel Numbers willPAUSE II
MUTESTOP nSURF
SCAN UP when the unit has been
identified. This may take up toVOLCH
two minutes.
ON/OFFPOSSWAPFREEZE
2
4Release the SURF and SystemSIZE4
(VCR or ACC) buttonsas soon
100+123
as channel numbers start to scan
TV/VCR456
up. The code has been identifiedENTER
SLEEP789
and the remote is ready to operate
SMART0
with the accessory device.
POWERVCRACCTV
MODE
STOP
SMART HELP2
4
Remember, a minute or two
can seem very long, but the
code should be located within two
minutes.
Don't let the accessory device scan up
more than five channels. The remote
may pass up the right code and another
two minute search cycle will have to
be repeated.
If no channel change happens within
two minutes, repeat steps 1-4. Should
a channel change still not occur, the
remote will not work with the desired
unit.
36 |
ACEC
