XP AJ 3380/00.3 22-06-2000 12:14 Pagina 4
CONTROLSINSTALLATIONRADIO/CLOCK
English
TOP AND SIDE PANELS see fig.1BACK PANELsee fig.1
1 ALARM 1:$ Battery door - for power backup battery
� BUZ (zer) - to activate buzzer for alarm 1% Pigtail aerial - for FM reception
setting
^ Mains lead - for mains supply
� RAD (io) - to activate radio for alarm 1
setting
MAINS CONNECTION
� OFF - to switch off alarm 1
1. Check if the mains voltage as shown on the
2 ALARM 2:
type plate on the base of the set corresponds
� BUZ (zer) - to activate buzzer for alarm 2
to your local mains supply.
setting
2. Connect the mains plug into the wall socket.
� RAD (io) - to activate radio for alarm 2
The mains supply is now switched on and the
setting -
numbers on the display will start to flash. You
� OFF - to switch off alarm 2
will need to set the correct time.
3 RADIO - to switch radio mode ON/OFF
3. To disconnect the set from the mains
4 BRIGHTNESS - to adjust the displaycompletely, withdraw the mains plug from the
illumination: HI-LOWwall socket.
For users in the U.K.: please follow the
5 Display - to show the hours, minutes and
instructions on page 2.
activated alarms
6 CLOCK:
FM/MW (LW) RADIO
� TIME SET - to adjust clock time
� ALARM 2 - to adjust/review ALARM 21. Set the RADIO switch to ON.
� ALARM 1 - to adjust/review ALARM 12. Select your waveband using the BAND switch.
� RUN - to return to clock time display after3. Use TUNING to find your radio station.
setting clock/alarm times4. Adjust the sound with the VOLUME and DBB
� 7, 4 - (fast up, slow down) - to adjustcontrols.
both the hours and minutes for the clock and5. To turn off the radio, set the RADIO switch to
alarm timesOFF.
7 SLUMBER - to activate slumber timeTo improve radio reception
� For MW (LW), the set is provided with a
8 ALARM RESET - to stop the active alarm
built-in aerial which to function best should be
for 24 hours
placed on a non-metallic surface e.g. wood,
9 DBB - to select an enhanced bass sound:
plastic. Direct the MW (LW) aerial by
Dynamic Bass Boost
adjusting the position of your clock radio.
0SLUMBEROFF / REPEAT ALARM� For FM reception extend the pigtail aerial at
� to switch off slumberthe back of the set completely to obtain
� to stop the active alarm for a 7 minuteoptimum reception.
period
! TUNING - to tune to radio stationsCLOCK
@ BAND - to select FM-MW (or LW) bandIllumination brightness
� To change the brightness of the clock display
# VOLUME - for adjusting the volume
illumination adjust the BRIGHTNESS switch to
HI or LOW.
4 |
ACEC
