AW 7150/AW 7250/00. page 7
Recording
STARTING AND STOPPING THE
RECORDING RECORDING
Copyright:Y To start recording, press RECORD 0 and
Recording is permissible insofar as copyrightPLAY 1 is then pressed at the same time.English
or other rights of third parties are not infringed.� When the end of the tape is reached, the
recorder buttons are released.
Safeguarding a cassette against erasure: Y To interrupt recording, press PAUSE ;.
Accidental erasure can be prevented byY To continue recording, press PAUSE ; again.
breaking the small tab in the top corner of theY Press STOP 9 if you want to stop the
back of the cassette.recording before the end of the tape. On
This protection can be reversedpressing again, the cassette holder will
1
with a piece of adhesive tapeopen.
placed over the same corner.Y The set is switched off if the TAPE/RADIO
Winding the tapeselector is in position TAPE and no buttons
are pressed.
Y Press F.FWD 5 to fast forward the tape.
Y Press REW 6 to fast rewind the tape.
Y Press STOP 9 to stop fast forward or fast-DUBBING � Copying from deck 1 to 2
rewind, or before the end of the tape.When dubbing, it is recommended to use
fresh batteries or to connect the set to the
RECORDING (on deck 2 only)mains supply.
Y Set the TAPE/RADIO selector to:
Y Press EJECT / to open the cassette holder.� DUBBING - for normal speed copying
Y Insert the cassette into deck 2.
For recording you must use a� HI-SPEED DUBBING - for high speed
copying
NORMAL cassette (IEC I) on
which the tabs have not beenDo not switch this selector during dubbing.
broken.Y Press both EJECT / buttons and insert a
At the very beginning of the tape, no
recording will take place during the firstrecorded cassette into deck 1 and a
cassette which is suited for recording into
seven seconds when the leader tape passes
the recorder heads.deck 2.
Y When monitoring during recording, adjustY Press PAUSE ; followed by RECORD 0 on
deck 2.
the sound with the controls VOLUME and
TONE. These controls do not affect theY To start dubbing, press PLAY 1 on deck 1.
Y Press PAUSE ; on deck 2 if you wish to
recording.omit undesired passages and the playback
Y To stop, Press STOP 9.
in deck 1 will continue. To restart dubbing,
press PAUSE ; again.
RECORDING FROM THE RADIO
Y By pressing PAUSE ; in deck 1 during
Y Set the TAPE/RADIO selector to RADIO.dubbing, a blank part will be recorded in
deck 2.
Mono recording from the built-in
microphoneY To stop dubbing, press both STOP buttons
9. The set is then switched off.
Y Set the TAPE/RADIO selector to TAPE
Y Set the VOLUME control to the minimum
volume level (during microphone recordings,
monitoring is not possible)
7 |
ACEC
