GENERAL INFORMATIONCD PLAY
CD player and CD handlingPlaying a CD
Y Do not touch the lens A of the CD player.This CD-player can play all kinds of Audio Discs such
Y Do not expose the unit, batteries or CDs to humidity,as CD-Recordables and CD-Rewritables. Do not try to
rain, sand or excessive heat (caused by heatingplay a CD-ROM, CDi, VCD, DVD, MP3-CD or computer
equipment or direct sunlight).CD.
YYou can clean the CD player with a soft, slightly
dampened, lint-free cloth. Do not use any cleaning
agents as they may have a corrosive effect.1 Push the OPEN 2 slider to open the player.
YTo clean the CD, wipe it in a straight line from the
center toward the edge using a soft, lint-free cloth. A2 Insert an audio CD, printed side up, by pressing the
cleaning agent may damage the disc! Never write on a CD or attach a stickerCD onto the hub.
to it.
Y The lens may cloud over when the unit is moved suddenly from cold to warm3 Close the player by pressing the lid down.
surroundings. Playing a CD is not possible then. Leave the CD player in a warm
environment until the moisture has evaporated.4 Press 2; to switch the player on and start playback.
Y Active mobile phones in the vicinity of the CD player may cause malfunctions.yThe current track number and elapsed playing
YAvoid dropping the unit as this may cause damage.time are displayed.
Headphones HE225YYou can pause playback by pressing 2;.
yThe time at which playback was paused starts
Y Connect the supplied headphones to the LINE OUT/p
flashing.
socket of the player.
Note: LINE OUT/p can also be used for YYou can continue playback by pressing 2; again.
connecting this set to your HiFi system.To adjust the
sound and volume, use the controls on the connected5 Press 9 to stop playback.
audio equipment and on the CD player.yThe total number of tracks and the total playing
time of the CD are displayed.
IMPORTANT!
Hearing safety: Do not play your headphones at a high volume. Hearing experts advise6 Press 9 again to switch the player off.
that continuous use at high volume can permanently damage your hearing.
Traffic safety: Do not use headphones while driving a vehicle. It may create a hazardYTo remove the CD, hold it by its edge and press the
hub gently while lifting the CD.
and it is illegal in many countries. Even if your headphones are an open-air type
designed to let you hear outside sounds, do not turn up the volume so high that you
cannot hear what is going on around you.Note: If there is no activity, the set will automatically
switch off after a while to save energy.
In-car use (connections supplied or optionally available)Playback information
Only use the AY 3545 or AY 3548 car voltage converter (4.5 V DC, positive pole toY If a CD-Recordable (CD-R) or a CD-Rewritable (CD-
the centre pin) and the AY 3501 car cassette adapter. Any other product may dam-RW) is not recorded properly, NF dISC is
age the set.displayed, indicating that the CD has not been
finalized. In that case, use FINALIZE on your CD
1 Put the set on a horizontal, vibration-free andrecorder to complete the recording.
12 V DC
stable surface. Make sure it is in a safe place,Y When playing a CD-Rewritable (CD-RW), please note
where the set is neither a danger nor an that it takes 3�15 seconds after pressing 2; for
obstacle to the driver and the passengers.sound reproduction to start.
2 Plug the voltage converter into the DvolBB4,5 V DCY Playback will stop if you open the CD lid.
repeat all
cigarette lighter socket (only for 12 V car
battery, negative grounding), then connectY While the CD is read, 1 -:- flashes in the display.
the wired end with 4.5V DC input socket on the
set.Volume and bass
3 If necessary, clean the cigarette lighter socket to obtain a good electrical Volume adjustment
contact.Y Adjust the volume by using VOL --//++ on the CD player
or the slider on the headphone cord.
4 Turn down the volume and connect the cassette adapter plug to LINE OUT/p
on the set.
5 Carefully insert the cassette adapter into the car radioOs cassette compartment.
Bass adjustment
vol
6 Make sure the cord does not hinder your driving.YPress DBB to switch the bass enhancement on or
off
7 Decrease the volume on the set if necessary. Start playback on the set andyis shown if the bass enhancement is
adjust the sound with the car radio controls.activated.
Y Always remove the voltage converter from the cigarette lighter socket
when the set is not in use.
Note: If your car radio has a LINE IN socket, it is better to use it for the
car radio connection instead of the adapter cassette. Connect the signal
lead to this LINE IN socket and to LINE OUT/p on the set. |
ACEC
