GENERAL INFORMATIONCD PLAY
CD player and CD handlingPlaying a CD
Y Do not touch the lens A of the CD player.This CD-player can play all kinds of Audio Discs such MODEESP
Y Do not expose the unit, batteries or CDs to humidity,as CD-Recordables and CD-Rewritables. Do not try toBASSIGITAL DYNAMIC BASS BOOSIBLTEDCD REWRITABLE COMPAT
rain, sand or excessive heat (caused by heatingplay a CD-ROM, CDi, VCD, DVD or computer CD.
equipment or direct sunlight).
Y You can clean the CD player with a soft, slightly OLDLINEOUT/VOL.OPEN
dampened, lint-free cloth. Do not use any cleaning1 Push the OPEN 2 slider to open the player.
agents as they may have a corrosive effect.
Y To clean the CD, wipe it in a straight line from the2 Insert an audio CD, printed side up, by pressing the
center toward the edge using a soft, lint-free cloth. A cleaning agent mayCD onto the hub. MODE
damage the disc! Never write on a CD or attach a sticker to it.ESP
Y The lens may cloud over when the unit is moved suddenly from cold to warm3 Close the player by pressing the lid down.
surroundings. Playing a CD is not possible then. Leave the CD player in a warmSS
A
environment until the moisture has evaporated.4 Press 2; to switch the player on and start playback.
Y Active mobile phones in the vicinity of the CD player may cause malfunctions.yThe current track number and elapsed playing
Y Avoid dropping the unit as this may cause damage.time are displayed.
Headphones HE545Y You can pause playback by pressing 2;.
yThe time at which playback was paused starts
Y Connect the supplied headphones to the LINE OUT/p�ashing.
socket of the player.
Note:LINEOUT/p can also be used for connecting theY You can continue playback by pressing 2; again.
player to your HiFi system (with a signal lead) or to
your car radio (with a cassette adapter or signal5 Press 9 to stop playback.
lead). In both cases, the volume of the player mustyThe total number of tracks and the total playing
be set to position 8.time of the CD are displayed.
IMPORTANT!6 Press 9 again to switch the player off.
Hearing safety: Do not play your headphones at a high volume. Hearing experts advise
that continuous use at high volume can permanently damage your hearing.Y To remove the CD, hold it by its edge and press the
hub gently while lifting the CD.
TrafŢc safety: Do not use headphones while driving a vehicle. It may create a hazard
and it is illegal in many countries. Even if your headphones are an open-air type
Note: If there is no activity, the set will automatically
designed to let you hear outside sounds, do not turn up the volume so high that you
cannot hear what is going on around you.switch off after a while to save energy.
0
In-car use (connections supplied or optionally available)Playback information
Only use the AY 3545 (4822 219 10033) or AY 3548 (3140 118 71890) car voltageY If a CD-Recordable (CD-R) or a CD-Rewritable (CD-RW) is not recorded
converter (4.5 V DC, positive pole to the centre pin) and the AY 3501 car adapterproperly, nF dISC is displayed, indicating that the CD has not been
cassette. Any other product may damage the set.Å¢nalized. In that case, use FINALIZE on your CD recorder to complete the
recording.
1 Put the set on a horizontal, vibration-free and
12 V DCY When playing a CD-Rewritable (CD-RW), please note that it takes 3�15
stable surface. Make sure it is in a safe place,
seconds after pressing 2; for sound reproduction to start.
where the set is neither a danger nor an
obstacle to the driver and the passengers.Y Playback will stop if you open the CD lid.
2 Plug the voltage converter into the Y While the CD is read, 1 -:- �ashes in the display.
MODE
cigarette lighter socket (only for 12 V car PROGRAMBASSESP4,5 V DC
battery, negative grounding), then connectOFFYERMSUEYHOLDPENVolume and bass
the wired end with 4.5V DC input socket on theLINEOUT/VOL.O
set.Volume adjustment
Y Adjust the volume by using VOL E.
3 If necessary, clean the cigarette lighter socket to obtain a good electrical
contact.
4 Turn down the volume and connect the adapter cassette plug to LINE OUT/pBass adjustmentE
on the set.Y Press BASS to switch the bass enhancement on or MODP
ES
5 Carefully insert the adapter cassette into the car radioOs cassette compartment.off
yis shown if the bass enhancement isGRAM
6 Make sure the cord does not hinder your driving.activated.BASS
7 Set VOL E on the set to position 8. Start playback on the set and adjust
the sound with the car radio controls.
YAlways remove the voltage converter from the cigarette lighter socket
when the set is not in use.
Remote control (supplied or optionally available)
Note: If your car radio has a LINE IN socket, it is better to use it for the Use the AY 3767 or AY 3768 cord remote control.The buttons on the remote
car radio connection instead of the adapter cassette. Connect the signalcontrol have the same functions as the corresponding buttons on the set.
lead to this LINE IN socket and to LINEOUT/p on the set.
1 Press 9 twice to switch off the set.
2 Firmly connect the remote control to LINE OUT/p on the set.
3 Adjust the volume VOL E on the CD player and remote control. |
ACEC
