EnglishCONTROLS / POWER SUPPLYPOWER SUPPLY / GENERAL INFORMATION
CONTROLS ( see Ţgure 1 )ECO-PLUS NiMH battery information (for versions supplied with the
rechargeable ECO-PLUS NiMH battery AY 3362)
1 OPEN 2..............opens the CD lid
Recharging works only on players supplied with the rechargeable ECO-PLUS
2 2;......................switches the player on, starts or pauses CD play
NiMH battery AY 3362.
3 9.........................stops CD play, clears a program or switches the player off
4 §.......................skips and searches CD tracks forwardsRecharging the ECO-PLUS NiMH battery on board
5 ESP......................EXTREME SHOCK PROTECTION ensures continuous CD play-1 Insert the rechargeable ECO-PLUS NiMH battery AY 3362.
back regardless of vibrations and shocks2 Connect the mains adapter to the 4.5V DC socket of
6 MODE.................selects the different playing possibilities: SHUFFLE, the player and then to the wall socket.
SHUFFLE REPEAT ALL, REPEAT, REPEAT ALLand SCAN
yis pulsing.
7 ............................display
Y Recharging stops after a maximum of 7 hours, or when you start playback.
8 PROGRAM..........programs tracks and reviews the program
9 BASS...................switches the bass enhancement on and off. This button also3 When the battery is fully recharged, and
switches acoustic feedback (the beep) on/off when it isFULL appear brie�y in the display,
pressed for more than 2 secondsbefore the display switches off.
0 .......................skips and searches CD tracks backwards
! RESUME.............stores the last position of a CD track playedNotes: � It is normal for the batteries to become warm
HOLD...................locks all buttonsduring recharging.
OFF......................switches RESUME and HOLD off� If the batteries become too warm, recharging will be interrupted for
approximately 30 minutes and Hot is displayed.
@ LINE OUT/p........3.5 mm headphone socket, socket to connect the player to
� To ensure proper recharging on board, take care that contacts are
another audio input of an additional appliance, remote
clean.
control socket (not on all versions)
� Use only the ECO-PLUS NiMH battery AY 3362.
# VOL E............adjusts the volume
$ 4.5V DC...............socket for external power supplyHandling instructions
% ............................belt clip holderY Recharging already charged or half-charged batteries will shorten their
lifetime. We therefore recommend that you let the rechargeable ECO-PLUS
^ ............................typeplate
NiMH battery run till it is completely empty before you recharge it.
Y To avoid a short circuit, do not let the battery touch any metal object.
Y If the battery becomes empty soon after recharging, then either its contacts
This set complies with the radio interference requirements of the are dirty or it has reached the end of its lifetime.
European Community.
Batteries (supplied or optionally available)Mains adapter (supplied or optionally available)
You can use the following batteries with this CD-player:Use only the AY 3170 adapter (4.5 V / 300 mA direct
Y normal batteries type LR6, UM3 or AA (preferably Philips), orcurrent, positive pole to the center pin). Any other product
may damage the player.
Y alkaline batteries type LR6, UM3 or AA (preferably Philips).
4.5VDC
1 Make sure the local voltage corresponds to the power
Notes:� Old and new or different types of batteries should not be combined.
adapterOs voltage.
� Remove batteries if they are empty or if the player is not going to be used for
a long time.2 Connect the power adapter to the 4.5V DC socket of
the player and to the wall socket.
Inserting batteries
Note: Always disconnect the adapter when you are not using it.
1 Push OPEN 2 to open the CD lid.
2 Open the battery compartment and insert either 2 Belt Clip (not on all versions)
normal or alkaline batteries, or the rechargeable
1 To attach the belt clip to the CD-player, position the
NiMH battery AY3362 (if supplied).
shaped grip (found on the back of the belt clip) soBELT CLIP
that it Ţts into the belt clip hole of the CD-player.
Battery indication
The approximate power level of your batteries is shown in the display.2 Turn the clip to LOCK as indicated on the set.
Battery full3 To detach, gently lift the belt clip and turn
Battery two-thirds fullto RELEASE as indicated on the set.
LOCK
Battery one-third fullLIFT
Battery dead or empty. When the batteries are
RELEASE
dead or empty, the symbol A �ashes, bAtt is
displayed, and the beep tone sounds repeatedly.
Average playing time of batteries under normal conditions
Battery typeESP onPower Save
Normal5 hours6 hoursEnvironmental information
Alkaline22 hours25 hoursY All redundant packing material has been omitted. We have done our utmost to
Rechargeable ECO-PLUS NiMH battery9 hours10 hoursmake the packaging easily separable into two mono materials: cardboard (box)
and polyethylene (bags, protective foam sheet).
Batteries contain chemical substances, so they should be disposed
of properly.Y Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the
disposal of packing materials, exhausted batteries and old equipment. |
ACEC
