AZ 1007/14 page 5
POWER SUPPLYGENERAL OPERATIONRADIO
AC MAINS
1. Check if the mains voltage as shown on the type plate on the
English
base of the set, corresponds to your local mains voltage. If it
does not, consult your dealer or service organisation.
2. If your set is equipped with a voltage selector, adjust it so
that it matches with the local mains.
3. Connect the mains lead to the MAINS socket and the wall
socket.
" The mains supply is now connected and ready for use.
4. To switch off completely, withdraw the mains lead from the
wall socket.
Y Disconnect the mains lead from the wall socket to protect
your set during heavy thunderstorms.
GENERAL OPERATION
1. To switch on the set, adjust the source selector.
2. Adjust the sound using the VOLUME and DBB controls.
3 To switch off the radio, adjust the source selector to thePPOWEROWERBBASS BOOSTASS DDYNAMICBYONODDBBASMTBICB
VVOLUMEOLUME
TAPE/POWEROFF position, with the cassette keys released.
PAUSESTOP-OPEN
SEARCH
RADIO RECEPTION
1 Set the source selector to RADIO.
2 Adjust the sound using the VOLUME and DBB controls.
3. Select the wave band FM/MW using BAND.PPOWEROWERBBASS BOOSTASS DDYNAMICBYONODDBBASMTBICB
VVOLUMEOLUME
4. Tune to a radio station using TUNING.
PAUSESTOP-OPEN
5. To switch off, set the source selector to the TAPE/POWEROFFSEARCH
position (with the cassette keys released).
To improve radio reception
Y For FM, pull out the telescopic aerial.POWERBASS BOOSTDYNAMICDBBDYNAMIC BASS BOOST
VOLUME
Incline and turn the aerial. Reduce its length if the signal is
too strong (very close to a transmitter).108FM17 AM
1091004130600092538001000TUNNING
Y For MW (AM), the set is provided with a built-in aerial soBAND88MHz kHz0
Y AYM FM
the telescopic aerial is not needed. Direct the aerial by
turning the whole set.
DYNAMIC BASS BOOST
DYNAMIC BASS BOOST
5 |