XP AZ 1018/00-1 13-12-2000 11:55 Pagina 7
Power Supply
Batteries contain chemical substances,
Switching power on/off:
so they should be disposed of properly.
Save energy
Incorrect use of batteries can cause
English
Whether you are using mains or battery
electrolyte leakage and will corrode the
supply, to avoid unnecessary energy
compartment or cause the batteries to
consumption always adjust the POWER
burst.Therefore:
slider to TAPE/OFF and check if the
Y Do not mix battery types: e.g. alkaline withcassette keys are released.
carbon zinc. Only use batteries of the sameR
CDRAADIOZCA1S0SET1T8ERECORDE
type for the set.LFITTOPONEMCWDTFAMPOFF
POWER
RECORD
PLAY
Y When inserting new batteries, do not try toEARCHPAUSESTOPYOPENSVOLUME
mix old batteries with the new ones.BALOWTT
PLAPAUSEY-
STOP
Y Remove the batteries if the set is not to be
CD MODEPROGRAM
used for a long time.SEAFMYMW
HRC
PRESET
Using AC Power
1 Check if the mains voltage, as shown on
General operation
the type plate located on the bottom
of the set, corresponds to your local1 To select your sound source adjust the
mains supply. If it does not, consult yourPOWER slider to CD, RADIO or
dealer or service centre.TAPE/OFF.
2 Adjust the sound with the VOLUME and
DBB (Dynamic Bass Boost) controls.
3 To switch off the set, adjust the POWER
slider to TAPE/OFF position and check
the cassette keys are released.
Note:When the set is switched off the tuner
presets will be retained in the setOs memory.
2 Connect the mains lead to the AC MAINS
inlet and the wall socket.The power supply
is now connected and ready for use.
3 To switch off completely, unplug the mains
lead from the wall socket.
Y Unplug the mains lead from the wall socket
to protect your set during heavy
thunderstorms.
The type plate is located on the
bottom of the set.
7 |
ACEC
