AZ 1035 /17 page 15
TROUBLESHOOTING
If a fault occurs, first check the points listed
WARNINGbelow before taking the set for repair.
Under no circumstances should you tryIf you are unable to solve a problem by
Englishto repair the set yourself as this willfollowing these hints, consult your dealer or
invalidate the warranty.
service center.
ProblemPossible causeSolution
No sound, VOLUME is not adjusted.Adjust volume.
no powerHeadphones are connected.Disconnect headphones.
Power cord is not securely connected.Connect the power cord properly.
Batteries are dead.Insert fresh batteries.
Batteries are inserted incorrectly.Insert batteries correctly.
Trying to change over from AC power to battery Remove the power cord from the
supply without removing the power cord.unitOs AC MAINS socket.
No reaction to Electrostatic discharge.Disconnect the set from power supply,
operation of any keysreconnect after a few seconds.
Poor radio reception Weak radio signal.Adjust the antenna for optimum
reception.
Interference caused by electrical equipment Keep the radio away from electrical
like TVs, computers, engines, etc.equipment.
no or E indication The CD is badly scratched or dirty.Replace or clean the CD.
No CD is inserted.Insert a CD.
The CD is inserted upside down.Insert CD with label facing up.
The laser lens is steamed up.Wait until the lens has cleared.
The CD skips tracks The CD is damaged or dirty.Replace or clean the CD.
SHUFFLEor PROGRAMis active.Switch off SHUFFLE or PROGRAM.
Poor cassette Dust and dirt on the heads, capstans, or Clean heads, capstans, and pressure
sound qualitypressure rollers.rollers.
Use of unsuitable cassette types Only use NORMAL type cassettes for
(METAL or CHROME) for recording.recording.
Recording does Cassette tab(s) may be snapped off.Apply a piece of adhesive tape over
not workthe opening.
Remote control does Batteries are inserted incorrectly.Insert batteries correctly.
not function properly Batteries are dead.Insert fresh batteries.
Distance to the set is too large.Reduce distance.
15 |