XP AZ 1065/17 20-10-2000 12:30 Pagina 17
AZ 1065 /17 page 17
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this will
Englishinvalidate the warranty.
PROBLEM
� POSSIBLE CAUSEindication
Y REMEDY� CD-R(W) is blank or the disc is not finalized
Y Use a finalized CD-R(W)
No sound/power� CD badly scratched or dirty
� VOLUME not adjusted
Y Adjust the VOLUMEY Replace/ clean CD, see Maintenance
� Headphones connectedThe CD skips tracks
Y Disconnect headphones
� CD is damaged or dirty
� Power cord not securely connectedY Replace or clean the CD
Y Connect the power cord properly
� SHUFFLE or PROGRAM is active
� Batteries dead/ incorrectly insertedY Quit SHUFFLE/PROGRAM mode(s)
Y Insert (fresh) batteries correctly
Poor cassette sound quality
Severe radio hum or noise� Dust and dirt on the heads, etc.
� Electrical interference: set too close to TV,Y Clean deck parts etc., see maintenance
VCR or computer
� Use of incompatible cassette types (METAL
Y Increase the distanceor CHROME).
Y Only use NORMAL (IEC I) for recording.
Poor radio reception
� Weak radio signalRecording does not work
Y FM: Direct the FM telescopic antenna for� Cassette tab(s) may be broken
optimum receptionY Apply a piece of adhesive tape over the
Y AM: Turn the set for optimum receptionmissing tab space.
or indicationRemote control does not function properly
� No CD inserted� Batteries dead/ incorrectly inserted
Y Insert a CDY Insert (fresh) batteries correctly
� CD badly scratched or dirty� Distance/ angle between the set too large
Y Replace/ clean CD, see MaintenanceY Reduce the distance/ angle
� Laser lens steamed up,
Y Wait until lens has cleared
The type plate is located on the bottom of the set.
17 |
ACEC
