TroubleshootingORIGINAL COPYRIGHT NOTICE
The making of unauthorized copies of copy-protected material,
If a fault occurs, first check the points listed below before taking the set for repair.
including computer programmes, files, broadcasts and sound
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.recordings, may be an infringement of copyrights and constitute a
criminal offence.This equipment should not be used for such pur-
WARNING:Do not open the set as there is a risk of electric shock.Under no poses.
circumstances should you try to repair the set yourself,as this will
invalidate the guarantee.
Problem� CD badly scratched or dirty
Y Replace/ clean CD, see Maintenance & Safety
� Possible cause
� Laser lens steamed up
Y RemedyYWait until lens has cleared
No sound /power� CD-R/CD-RW is blank or not finalized
� Volume not adjusted
Y Use a finalized CD-R or CD-RW only
Y Adjust the VOLUMENote:Environmental information
� Power cord not securely connected
Make sure the CD is not encoded withAll unnecessary packaging material has been omitted.The packaging can be easily separat-
Y Connect the AC power cord properlyCopyright protection technologies,as someed into three materials: cardboard, polystyrene and plastic.
� Batteries dead/ incorrectly inserted
do not conform to the Compact Disc stan-
Y Insert (fresh) batteries correctlydard.Your set consists of materials which can be recycled if disassembled by a
� Headphones connected to the setspecialized company. Please observe the local regulations regarding the
The CD skips tracks
Y Disconnect headphones..disposal of packaging, dead batteries and old equipment.
� CD damaged or dirty
Display does not function properly/ NoY Replace or clean CD
reaction to operation of any of the con-
� Programme/RAMDOM is active
trolsY Quit programme/RANDOM mode
� Electrostatic dischargeNote:
Y Switch off and unplug the set. Reconnect after a
For a disc with CD Audio tracks and MP3
few secondsfiles,only the CDAudio tracks will be
Remote control does not function played.
properly
The MP3-CD skips albums
� Batteries exhausted/ incorrectly inserted
Y Insert (fresh) batteries correctly� CD contains non-MP3 file folders
Y Check your disc contains suitable file folders.
� Distance/ angle between the set too large
Y Reduce the distance/ anglePoor cassette sound quality
Severe radio hum or noise� Dust and dirt on the heads,etc.
� Electrical interference:set too close to TV,VCR orY Clean deck parts, see Maintenance
computer� Use of incompatible cassette types (METAL or
Y Increase the distanceCHROME)
Y Only use NORMAL (IEC I) for recording
Poor radio reception
Recording does not work
� Weak radio signal
Y FM:Adjust the FM telescopic aerial� Cassette tab(s) may be broken
Y Apply adhesive tape over the missing tab space
---indication
� No disc inserted
Y Insert asuitable disc |
ACEC
