XP AZ 1575/01 05-10-2000 09:23 Pagina 13
AZ 1575 /01 page 13
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Do not open the set as there is a risk of electric shock. Under no
Englishcircumstances should you try to repair the set yourself, as this will
invalidate the guarantee.
PROBLEMindication
� POSSIBLE CAUSE
Y REMEDY� CD-R(W) is blank or the disc is not finalised
Y Use a finalised CD-R(W)
No sound/powerThe CD skips tracks
� VOLUME not adjusted� CD damaged or dirty
Y Adjust the VOLUMEY Replace or clean CD
� Headphones connected� SHUFFLE or PROGRAM is active
Y Disconnect headphonesY Switch off SHUFFLE / PROGRAM
� Mains lead not securely connected
Y Connect AC mains lead properlyPoor cassette sound quality
� Dust and dirt on the heads, etc.
Y Clean deck parts, see Maintenance
Severe radio hum or noise
� Electrical interference: set too close to TV,� Use of incompatible cassette types (METAL
VCR or computeror CHROME)
Y Only use NORMAL (IEC I) for recording
Y Increase the distance
Poor radio receptionRecording does not work
� Weak radio signal� Cassette tab(s) may be broken
Y Apply a piece of adhesive tape over the
Y FM: Direct the FM telescopic aerial formissing tab space.
optimum reception
indicationRemote control does not function properly
� Batteries exhausted
� CD badly scratched or dirty
Y Replace/ clean CD, see MaintenanceY Insert fresh batteries
� Laser lens steamed up,� Batteries incorrectly inserted
Y Insert the batteries correctly
Y Wait until lens has cleared� Distance/ angle between the set too large
Y Reduce the distance/ angle.
Environmental information
All unnecessary packaging material has been omitted. We have done our utmost to make the
packaging easy to separate into three mono-materials: cardboard (box), expandable polystyrene
(buffer), polyethylene (bags, protective foam).
Your set consists of materials which can be recycled if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packing
materials, exhausted batteries and old equipment.
13 |
ACEC
