XP AZ 2425/17 19-09-2000 13:19 Pagina 18
TROUBLESHOOTING
EnglishIf a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service
center.
WARNING: Under no circumstances should you try to repair the set yourself, as this would
invalidate the warranty.
PROBLEMCD playback does not work
� POSSIBLE CAUSE� CD is badly scratched or dirty.
Y REMEDYY Replace or clean the CD, see Maintenance.
� Laser lens steamed up
No sound/powerY Wait until lens has acclimatized
� VOLUME is not adjusted.
Y Adjust the VOLUME.
The CD skips tracks
� Headphones are connected.� CD is damaged or dirty.
Y Disconnect headphones.Y Replace or clean the CD.
� Batteries are exhausted.� PROGRAM/SHUFFLE is active.
Y Insert fresh batteries.Y Switch off the PROGRAM/SHUFFLE function.
� Batteries are incorrectly inserted.
Y Insert the batteries correctly.Poor cassette sound quality
� Pwer cord is not securely connected.� Dust and dirt on the heads, capstan or
Y Connect the power cord properly.pressure roller.
Y Clean the heads etc., see Maintenance.
� Batteries loaded but power cord still plugged� Use of incompatible cassette types (METAL
in and connected.or CHROME).
Y Pull out the power cord from the MAINSY Only use NORMAL (IEC I) for recording.
outlet and the set.
Reversed left and right sound/no soundRecording does not work
from one speaker� Cassette tab(s) may be broken out.
� Speakers incorrectly connectedY Apply a piece of adhesive tape over the
Y Connect properly: L to left, R to rightmissing tab space.
Remote control does not function properly
Poor bass sound� Batteries are exhausted.
� Speakers not in phase.Y Insert new batteries.
Y Connect speaker poles correctly, �+O pole (red
marked wire) to �+O; ��Opole (black/unmarked� Batteries are incorrectly inserted.
wire) to ��O.Y Insert batteries correctly.
� Distance or angle between the set is too
large.
Y Reduce the distance or angle.
The type plate is located on the base of the set.
18 |
ACEC
