44 SmartLock (contOd)
To change the access code, follow these steps.
6 2,4
1
Press the MENU button.
>SMARTLOCKPRESS B
REVIEWEJECT
EXITPOWER
PRIM. SETUPMENUSTATUS/EXITCLEAR
VCR PROGRAM
VCR SETUP
1
123
456
25
789
Press the PLAY/s button or the STOP/t button to selectSLEEP/WAKE UPALT.CH
SMARTLOCK. Then, press the F.FWD/B button.0
3
SMARTLOCK
RECPAUSE
/OTR/STILL
_ _ _ _PLAY
REWF.FWD
Enter Your Access Code
STOP
CH.VOL.
3
MUTE
Use the Number buttons to enter your old access code.
The default code is 0711. If you have never set up your personal
access code, use 0711 now.SPEED
After you enter the code, the SMARTLOCK menu will appear.
TRACKINGMEMORY
SMARTLOCK
X X X -
Enter Your Access Code
4
Press the PLAY/s button or the STOP/t button to select
CHANGE CODE. Then, press the F.FWD/B button.
SMARTLOCK
BLOCKHelpful Hints
>CHANGE CODEY To protect the privacy of the access
code, an X will appear on the screen
SELECT KL CHOOSE B
TO END PRESS EXITinstead of the number you enter.
Y If a OWrong Code...� message
appears on the screen after you com-
5plete step 5, you entered the wrong
numbers in the Confirm Code space.
Use the Number buttons to enter your desired access code
Repeat the steps on this page.
in the New Code space. Then, enter the same code in the
Y You cannot use the default code after
Confirm Code space.
you set up your personal access code.
Your new access code should be recorded. You will return to the
Y If a power failure occurs, the default
SMARTLOCK menu.
code, 0711, will be the active access
New Code_ _ _ _code again.
Confirm CodeY If you connect the power cord to an_ _ _ _
AC outlet that is controlled by a wall
switch, your personal access code will
be erased every time you turn off the
power at the wall switch. The default
6
code will be the active code again.
Press the STATUS/EXIT button. |
ACEC
