32 Timer Recording
Follow the steps below to program the TV/VCR to record TV
programs while youOre away from home. The TV/VCR will turn
itself on, record, and turn itself off automatically. (The Record2-3
light will be on steadily during the recording. Before you begin,
make sure:
The clock is set. If not, CLOCK MUST BE SET appears, fol-
lowed by the SET CLOCK menu. Details are on pages 12-17.POWEREJECT
Channels are set. Details are on page 10.MENUSTATUS/EXITCLEAR
A tape is in the TV/VCR. Make sure the tapeOs record tab is
1
intact and the tape is long enough to record the program.123
Complete each step within 60 seconds of completing the
456
previous step. If you donOt, you may start again at step 1.
789
SLEEP/ALT.CH
WAKE UP
0
1
RECPAUSE
Press the MENU button./OTR/STILL
PLAY
REWF.FWD
>PRIM. SETUPPRESS B
STOP
VCR PROGRAM
VCR SETUP
CAPTION
CH.VOL.
REMINDER
BRIGHTNESSMUTE
FM
SPEEDF.ADV
2
Press the PLAY/ button or the STOP/ button to selectTRACKINGMEMORYSLOW
VCR PROGRAM, then press the F.FWD/B button.
VCR PROGRAM
>ONCE
DAILY(MON-FRI)
WEEKLY
PROGRAM REVIEW
SELECT KL CHOOSE B
TO END PRESS EXIT
3
Press the PLAY/ button or the STOP/ button to select
a ONCE, DAILY, OR WEEKLY recording. Then, press
the F.FWD/B button.Helpful Hints
ONCE: The TV/VCR will record a TVprogram on any day you
Y With ShowGuard, you donOt have to
choose, up to 12 months away.
worry about losing your timer
DAILY:The TV/VCR will record every day from Monday to
recordings. If the power fails, timer
Friday � starting at the same time and recording the same channel
recordings will be restored when the
for the same length of time.
clock is reset. (The clock will reset
WEEKLY: The TV/VCR will record the same channel on the
itself automatically if you are using
same day, at the same time, and for the same length of time
AUTO CLOCK. Details are on pages
every week.
14-17. If you are not using AUTO
DAILY PROGRAM (MON-FRI)CLOCK, reset the clock manually.
DailyPROGRAM -1 2 3 4 5 6 7 8-
Details are on pages 12-13.) The
Recording
timer recording will not occur only if
(example)it was scheduled to take place dur-
SELECT PROGRAM NUMBER
ing the power failure.
TO END PRESS EXIT
Y You cannot set a timer recording if
DEFEATRECORDING is ON.
Details are on page 36. |
ACEC
