8 Turning On the TV/VCR
Before you turn on the TV/VCR, make sure batteries are in the
remote control and you have connected the TV/VCR correctly.
The instructions on this page work only when you turn on the12
TV/VCR for the first time.
1EJECT
POWER
Press the POWER button. The TV/VCR will come on and the
MENUSTATUS/EXITCLEAR
screen shown below will appear.
3
SELECT LANGUAGE123
> ENGLISH ON456
ESPA?OL5
789
SELECT KL ORSLEEP/WAKE UPALT.CH
PRESS MENU TO CONTINUE0
RECPAUSE
/OTR/STILL
PLAY
2REWF.FWD
Press the PLAY/K button or the STOP/L button to select
STOP4
English or Spanish on-screen displays and menus.
CH.VOL.
MUTE
3FM
Press the MENU button. The screen shown below will appear.
SPEEDF.ADV
CONNECT ANTENNA OR CABLE
TO TVCRTRACKINGMEMORYSLOW
THEN PRESS B
TO END PRESS EXIT
4
Press the F.FWD/B button to begin automatic channelHelpful Hints
setup. The TV/VCR will memorize all available channels. When
Y If you do not see any on-screen dis-
channels are set, CHANNELS ARE SET will appear on the screen
plays when you turn on the TV/VCR,
briefly. Then the TV/VCR will go to the lowest available channel.
check your hookups, then try again.
If you try to set up channels when there is no antenna or cable
If you still do not see any on-screen
connected to the TV/VCR, programming will appear to take place,
displays, follow the steps on pages
but eventually a NO TV SIGNALS ... message will appear on the
nine-10 to select a language and set
screen. Connect an antenna or cable to the ANT(enna) jack on
up channels.
the TV/VCR, then press the F.FWD/B button again. You mayY To skip step 2, press the MENU but-
need to follow the steps on page 10 instead.
ton. All on-screen displays will be in
English. To skip step 4, press the
STATUS/EXITbutton. Automatic
Channel Setup will not occur, and
5CHANNELS NOT SET will appear on
Use the CH(annel) o/p buttons or the Number buttonsthe screen briefly.
on the remote control to select a TV/VCR channel. UseY You cannot set up channels if you are
the VOL(ume) o/p buttons to adjust the sound.using a Cable Box.
When you scan channels with the CH(annel) o/p buttons, onlyY Line Input mode is channel 00.
When you select channel 00, A/V IN
the memorized channels will be available. Use the Number but-
will appear on the screen. Press the
tons to select non-memorized channels.
CH(annel) o/p buttons or the
Number buttons to select another
channel. |
ACEC
