CCZ256comb.QX33 4/6/99 9:13 PM Page 8
8 Turning On the TV/VCR
Before you turn on the TV/VCR, make sure there are batteries in
the remote control and the TV/VCR is hooked up correctly.
The instructions on this page work only when you turn on thePOWEREJECT
TV/VCR for the first time.
1SLEEPSPEEDMEMORY
REC/OTRPAUSE/STILL
1PLAY
Press the POWER button. The TV/VCR will come on and theREWF.FWD
STOP4
screen shown below will appear.
MENUSTATUS/EXITCLEAR
SELECT LANGUAGE3
1 ENGLISH ON
123
2 ESPA?OL
CH.
2
MAKE SELECTION OR456
PRESS EXIT TO CONTINUE
789
5
A.CH0+100
VOL.
CABLE/DBSCOMBI
2
VCR PLUS+
VAR.SLOW/ENTERMUTE
Press the Number 1 button to select English on-screen
TRACKINGF.ADVSLOW
displays or press the Number 2 button to select Spanish
SMARTSMARTSKIPINDEX
on-screen displays.PICTURESOUNDSEARCHSEARCH
3
Press the STATUS/EXIT button. The screen shown below
will appear.
CONNECT ANTENNA OR CABLE
TO TVCR
THEN PRESS B
Helpful Hints
TO END PRESS EXIT
Y If you do not see any on-screen dis-
plays when you turn on the TV/VCR,
check your hookups, then try again.
4If you still do not see any on-screen
Press the F.FWD/ B button to begin automatic channel
displays, follow the steps on pages
setup. The TV/VCR will memorize all available channels. Whennine - 10 to select a language and
channels are set, CHANNELS ARE SET will appear on-screen
set up channels.
briefly. Then the TV/VCR will go to the lowest channel pro-
Y To skip step 2, press the
grammed.
STATUS/EXIT button. All on-screen
displays will be inEnglish. To skip
step 4, press the STATUS/EXITbut-
5ton. Channels will not be set up,
Use the CH(annel). Up/Down buttons or the Numberand CHANNELS NOT SET will
buttons on the remote control to select a TV/VCR chan-appear on-screen briefly.
nel. Use the VOL(ume). Up/Down buttons to adjust the
Y You cannot set up channels if you
are using a Cable Box.
Y Line Input mode will always be
stored in the TV/VCROs memory as
channel 00. When you select chan-
nel 00, A/V IN will appear on-
screen briefly. Press the CH(annel).
Up/Down buttons or Number but-
tons to select another channel. |
ACEC
