CD245_IFU_EN_UK_version.book Page 39 Thursday, Janua07 ry 2 5:55, 24 PM0
The following table indicates how to
8.7.2.1Activate/Deactivate access the below features during remote
access procedure:
Remote Access
1Press m key in idle mode, scroll 1Go to previous message
: to ANSW MACHINE and press
Play all recorded messages
mOK, scroll : to ANSW 2
(new and old) or play
SETTINGS and press mOK, scroll
current message again
: to REMOTE ACC. and press
Go to next message
mOK.3
2Scroll : to ACTIVATED or
Play the current outgoing
DEACTIVATED and press mOK to 5
message
confirm.
Delete current message
A validation tone is emitted and the 6
screen returns to previous menu.
Stop message playback or
8
stop outgoing message
playback
8.7.2.2Controlling the
Answering Machine from
an external call
1From another phone, dial home. 8.8Call Screening
The answering machine answers
and starts playing your greeting
message.8.8.1 Set Handset Call Screening
2Within 8 seconds, press # key on the If Handset call screening is set to On, you
phone you used to dial and enter the can hear the incoming message via the
remote access code (same as your handset speaker and decide whether or
Master PIN code).not to pick up a call. To take the call,
If the access code is incorrect, an press r.
error tone will be emitted. After the This feature is deactivated by default.
error tone is emitted, you can try to 1Press m key in idle mode, scroll
press the remote access code again : to ANSW MACHINE and press
until you enter the correct number.mOK, scroll : to ANSW
The answer machine will drop the SETTINGS and press mOK, scroll
line immediately if there is no : to HS SCREENING and press
detection of the master PIN entry mOK.
within 8 seconds. 2Scroll : to ON or OFF and press
If the remote access code is correct, mOK.
a validation tone can be heard. A validation tone is emitted and the
screen returns to previous menu.
Telephone answering machine (TAM)39 |
ACEC
