? Check to see if the answering machine is
Soundmemory full. If so, delete some or all
messages.
Handset does not ring!? Try switching off the power at the main
? Increase the volume socket, and then turn it on again after
? Make sure that the adaptor and the phone1 minute.
cord are connected properly
? Move the handset closer to the base unitUnable to perform remote operation
? Make sure the handset ringer is turned on? Make sure the remote access is on (see
Section 6.6.4.2)
Caller does not hear me!? Make sure you entered the correct remote
? Microphone may be muted : During a call,access code
press .? Use a touch-tone phone
Note
Noise interference on your radio orIf the above solutions do not help, remove the
televisionpower from both the handset and the base.
? Move the power adaptor or base station asWait for 1 minute and try again.
far away as possible
Product behaviour
Caller Line Identification (CLI) service
does not work
? Check your subscription with your network
operator
A phonebook entry cannot be stored
? Check if the phonebook memory is full,
delete an entry to free memory.
The handset is unable to register
? Make sure that has been pressed for
3 seconds
? Each base can only register up to four
handsets
Answering Machine
The answering machine does not record
calls.
? Make sure the answering machine is
connected to the power adaptor, and the
power adaptor is plugged into mains supply
which is switched on.
? Check if the answer machine is off, or
Answer only mode is selected.
38Frequently asked questions |
ACEC
