How to connect your recorder
Digital optical connectionAC Power supply
Instead of the digital coaxial connection you can make use of
the optical input..Optical connections are less sensitive to
English
external disturbances.This connection is required for direct
recording from an external digital optical source (e.g.a CD
player,DVD,DAT).
CD PLAYER
1Check whether the AC power voltage as shown on the
type plate corresponds to your local power voltage. If it
CD RECORDER2
does not, consult your dealer or service organisation.
CDCDRCDCDRCDRCDRCD
CDR
LLL
RRR2Make sure all connections have been made before
OUT OUTOUTININ
ANALOG DIGITALANALOGDIGITALOPTICALOUTIN
switching on the AC power supply.
3Plug the power cord supplied into the AC POWER ~
1Remove the dust caps from the digital optical connectionsconnector and the CD recorder, then into the wall jack.
of both source and CD recorder. Keep the caps in a safe
4Press POWER ON/OFF.
place.
�The CD recorder will switch on.This may take a few
2Connect an optical Ţbre-optic cordseconds.
between the OPTICAL IN jack of
Notes:
the CD recorder and the
If the CD recorder is in Standby mode (red LED on),press
OPTICAL OUT jack of the source.
any button to activate the recorder.
Make sure you insert both plugs
When the CD recorder is in the OOFF�position,it is still
fully, until a click is heard.
consuming some power.If you wish to disconnect your CD
�Recording can now be done via the digital optical inputrecorder completely from the power,withdraw the plug from
(OPTICAL).the AC Outlet.
Digital coaxial connections via a digital receiver
If you have a receiver with digital coaxial in- and outputs,these
connections allow you to make digital recordings from various
sources,connected to the receiver.
DIGITAL
RECEIVER
CD RECORDER
11
CDCDRCDRCDCDRCDRCDCDR
LL
L
RCD RECORDERR
OUTR
ANALOG DIGITALOUTINANALOGOUTINDIGITALOUTOPTICALIN
1Connect a digital coaxial cord between the DIGITAL IN-
and OUT jacks on the CD recorder and e.g. the (digital)
AUX in- and output jacks on the digital receiver.
�Any digital device,connected to the digital input jacks of
the digital receiver (e.g. CD and DVD) can now be used
as recording source.
Note:Your CD recorder is equipped with a digital coaxial
output (common output for CD recorder & CD player deck).
This output can be used for digital playback.
15 |
ACEC
