FIXING PROBLEMS
Englishtray." make sure the recording level is correct
20 second pause between recordings
Troubleshooting
" see synchronized digital recording (CD-SYNC) p. 8
If you think your CD recorder is defective, it is wise to checkPlayer does not react
this list first and run the diagnostic program. Maybe you have" switch the ON/OFF button on the front of the
forgotten a simple step.player off and back then on
Warning!
SERVICE on display after switching on
Under no circumstances should you attempt to repair
"try switching off and on again
the CD recorder yourself as this will invalidate the
guarantee.
RECOVER on display
" a power failure has occurred during recording;
SYMPTOM:" SOLUTION:the CD recorder is attempting to repair the
disc.
No power " check to ensure that the ON/OFF button is on
" if RC-DISC then appears on the display, the
" check to ensure that the power cable is
disc cannot be recorded further, and cannot be
plugged in correctly
finalized. However, it can be played on a CD
" switch the recorder OFF and then immediately
recorder.
back ON
" on a CD-RW disc, the track being recorded is
lost, but further recording and finalization can
Auto track does not work
still be done.
" check to ensure that auto track is selected.
" if OPC FAIL appears, no further recording
" check to ensure that there are 3 seconds
is possible. You can still use the disc as a CD
silence in between the tracks (analogue
on this recorder.
recording only)
" check to ensure that the source is a consumer
source with the digital output according the
IEC audio standard.Diagnostic program
No sound " check the audio connections
If the malfunction continues, perform the Diagnostic Program:
" if using an amplifier, try using a different
source
1 Switch the recorder off using ON/OFF.
Amplifier sound is distorted
" check to ensure that the CD recorder analogue2 Simultaneously press PLAY and STOP and switch the
output is not connected to the amplifier Phonorecorder back on using ON/OFF.
input.� The display will now indicate BUSY and after a few
minutes, the message will change to ERROR or
Play will not startPASSED
" check to ensure that the label of the CD is
facing up" If the ERROR message appears, your recorder is
" clean the discdefective and needs to be repaired. Consult your supplier
" check to ensure that the disc is not defectiveor call the Philips Consumer Line to find the nearest
by trying another discservice center. The number of the Consumer Line can be
found in the guarantee booklet.
Remote control does not work
" point the remote control directly at the CD
" If the PASSED message appears, you may be
recorder
misinterpreting the user instructions or using an
" check the batteries and replace if necessary
inappropriate disc, or there may be a mechanical defect or
" select the right source first
an incorrect connection. Carefully read the user
Will not recordinstructions once again; and if necessary contact your
" clean the disc.supplier.
" check to ensure that CD-RW is not finalized
" check to ensure that the disc is recordable and" If you cannot solve the problem, contact to the nearest
replace if necessaryservice center.
" the disc is not an AUDIO disc
" wrong input source selected.3 Switch off the recorder using ON/OFF to exit from the
Diagnostic Program.
Analog recording is distorted
18 |
ACEC
