DV910(H9100).QX33 01.8.9 10:26 AM Page 16
16 Turning on Your DVD/VCR
Before turning on your DVD/VCR, make sure batteries are in the
remote control and the DVD/VCR and TV are connected correctly.
Turn on the TV.
You can not program channels if you are using a Cable Box or a
2
Direct Broadcast System.
POWER
MARKER
SETUPAUDIOSUBTITLEANGLE1
1
MENUTITLE
Press the VCR button, then press the POWER button. OP-
ON� will appear briefly on the front of the DVD/VCR.The greenOK4
VCR OUTPUT light, the VCR/TV light, and the POWER light willMODERETURN
appear on the front of the DVD/VCR.OUTPUT SELECT
DVDVCR
SKIP/CHANNELCHANNEL/SKIP
H/LK/G
2B5
Turn on the TV. Set it to the same channel as the CH3/CH4
ED
switch on the back of the DVD/VCR. The display shown below
will appear. (If the display does not appear, check your hookups, thenRECCF
/OTR3
follow the steps on page 17 to set up channels and page 22 to selectA-B
a language.)CLEAR
REPEAT
DISPLAY
SELECT op
123
STATUS/EXIT
? ENGLISH ONSEARCH MODE
ESPA?OL456
TIME SEARCH
SLOW
789
MAKE SELECTION ORZOOM
PUSH MENU TO CONTINUE+100
TIMER SET VCR/TV MEMORY SPEED
3
Within 60 seconds, press the Play B button or the Stop C
button to select English or Spanish on-screen displays and
menus.
Helpful Hints
4
Press the MENU button.Y To skip this feature and play a tape
immediately,insert a tape with its
CONNECTANTENNA ORCABLE
record tab removed.Or,to skip step
TOVCR
3,press the MENU button.All on-
THEN...
screen displays will be inEnglish.To
PUSHCHUPKEY
skip step 5,press the Stop C but-
OR...
FOR PLAY ONLY - PUSH STOPton. Channels will not be pro-
grammed,and CHANNELS NOT
SETwill appear on the screen.
5Y If you try to program channels when
Within 60 seconds, press the CHANNEL o button to beginthere is no antenna or cable con-
automatic channel programming. AUTO CH PROGRAMMINGnected to the DVD/VCR,program-
IN PROCESS PLEASE WAIT will appear on the TV screen.Theming will appear to take place,but
DVD/VCR will memorize all available channels.When all channels areeventually a NOTVSIGNALSmes-
memorized, CHANNELS ARE SET will appear on the screen briefly,sage will appear.Connect an anten-
then TV programming will appear.na or cable to the DVD/VCROs ANT-
These channels will be available when you want to watch TV while inIN (Antenna In) jack and press the
VCR mode.To put the DVD/VCR in VCR mode, press the OUTPUTCHANNEL o button again.If chan-
SELECT button so that the green VCR OUTPUT light appears.Thennel programming does not resume,
press the VCR/TV button so that the VCR/TV light appears. Press thefollow the steps on page 17.
VCR button, then use the CHANNEL and Number buttons to selectY You may need to repeat the steps
a TV channel for viewing.on this page if the power fails. |
ACEC
