Getting Started
EnglishStep 1: Inserting batteries intoStep 2: Setting up the TV
the Remote Control
IMPORTANT!
Make sure you have completed all
3
the necessary connections. (See
1page 6-7 OConnecting TV�).
2
1Turn on the TV and set to the correct
video-in channel. You should see the DVD
background screen on the TV.
1Open the battery compartment.2Usually these channels are between the
lowest and highest channels and may be
2Insert two batteries type R06 or AA,
following the indications (+-) insidecalled FRONT, A/V IN, or VIDEO. See your
TV manual for more details.
the compartment.� Or, you may go to channel 1 on your
3Close the cover.TV, then press the Channel down button
repeatedly until you see the Video In
channel.
Using the Remote Control to� Or, the TV Remote Control may have a
operate the Playerbutton or switch that chooses different
video modes.
1Aim the Remote Control
� Or, set the TV to channel 3 or 4 if you
directly at the remoteare using an RF modulator.IR
sensor (iR) on the front
panel.3If you are using external equipment, (eg.
audio system or receiver), turn it on and
2Do not put any objectsselect the appropriate input source for
between the Remotethe DVD Player output. Refer to the
Control and the DVDequipment ownerOs manual for detail.
Player while operating the
DVD Player.
PREVIEW MUTE
CAUTION!DIMSLEEP SOUNDSURROUND
� Remove batteries if they are
exhausted or if the Remote Control
is not being used for a long time.
� Do not use old and new or
different types of batteries in
combination.
� Batteries contain chemical
substances, so they should be
disposed properly.
12
01-30 DVD622_9331220/10/2004, 11:02 AM3139 246 14493 |
ACEC
