English
Note:
General Explanation
� If the audio format of the digital output does not match the
capabilities of your receiver, the receiver will produce a strong,
About this manual
distorted sound or no sound at all.
� Six Channel Digital Surround Sound via digital connection
This manual gives the basic instructions for operating the
can only be obtained if your receiver is equipped with a Digital
DVD player. Some DVDs require specific operation or
Multi-channel decoder.
allow only limited operation during playback which may not
� To see the selected audio format of the current DVD in the
respond to all operating commands. When this occurs, the
Status Window, press SYSTEM MENU or Audio.
symbol ? appears on the TV screen, indicating that the
operation is not permitted by the player or the disc.
NTSC/PAL Settings
Remote control operation
You can switch the NTSC/PAL setting of the DVD player to
? Unless stated, all operations can be carried out with the
match the video signal of your TV. This setting only affects
remote control. Always point the remote control directly at
the televisionOs on-screen display that shows the stop and
the player, making sure there are no obstructions in the
setup modes. You may select either NTSC or PAL. To
path of the infrared beam.
change the DVD player setting to PAL or NTSC, follow the
Corresponding keys on the front panel of the player can
steps below.
also be used.
1Unplug the DVD player from the mains.
2Press and hold 9 and T, on the front of the DVD player.Menu bar operation
While holding 9 and T, plug in the mains.
? A number of operations can be carried out via the menu
3After PAL or NTSC appears on the display panel of the
bar on the screen. The menu bar can be accessed by
DVD player, release 9 and T, at the same time. The PAL
pressing the cursor keys on the remote control.
or NTSC that appears on the display panel indicates the
? Pressing SYSTEM MENU while the menu bar is displayed
current setting.
will clear the menu bar from the screen.
4To change the setting, press T, within three seconds. The? The selected item will be highlighted and the appropriate
new setting (PAL or NTSC) will appear on the displaycursor keys to operate will be displayed below the icon.
panel.? < or > indicates that more items are available at the left/
right of the menu bar. Press 1 or 2 to select these items.
NTSC/PAL Conversion (DVD622
only)
This player is equipt. with NTSC/PAL conversion feature to
convert the video output of the disc to match with your TV
system. The conversion supported are as per below.
DiscOutput format
TypeFormatSelected mode
NTSCPALAUTO
DVDNTSCNTSCPALNTSC
Not
PALSupportedPALPAL
VCDNTSCNTSCPALNTSC
PALNTSCPALPAL
1In the Preference Menu, select TV System.
2Press 3 or 4 to select PAL, NTSC or AUTO.
Notes:
� AUTO can only be selected when using a TV that has both
the NTSC and PAL systems.
� This is applicable for CVBS output on cinch and SCART only
� Slight picture distortions may occur due to this conversion.
This is normal. Thus, the AUTO format is most suitable for the
best picture quality.
10PREPARATION |
ACEC
