Preparation
Switching On EnglishInserting batteries into the
Remote Control
1Be sure that the DVD player has been correctly
1Open the battery cover by pressing in the tab,connected to the TV and audio equipment.
then lift off the cover.2Switch on the TV and DVD player.
2Insert batteries with the correct polarity as3Set the TV to the correct Video In channel. (eg.
indicated by the + and - symbols inside theEXT1, EXT2, AV1, AV2, AUDIO/VIDEO, etc.
battery compartment.Please refer to your TV owner's manual for
3Close the cover.details.)
� The player display lights and the default screen
appears on the TV.
4If you are using an external equipment (eg. audio
-
+system or receiver), turn it on and select the
appropriate input source for the DVD player
output. Refer to the equipment ownerOs manual
+
-for detail.
Smart Power On/Off
CAUTION!When in STOP or NO DISC mode, the DVD
player will switch to standby mode after 15
� Remove batteries if they are exhausted
or not to be used for a long time.minutes without any operations for saving energy.
� Do not use old and new or differentIt is easily reactivated by pressing the POWER or
types of batteries in combination.PLAY key on the remote control or the
�Batteries contain chemical substances,STANDBY-ON button on the front panel.
so they should be disposed off properly and
kept away from children.
Using the Remote Control
I Direct the remote control at the remote sensor
of the DVD player.
I Do not drop or give the remote control a shock.
I Do not leave the remote control in extremely
hot or humid places.
I Do not spill water or put anything wet on the
remote control.
11 |
ACEC
