H9231CD(EN).QX3 02.9.5 7:13 PM Page 35
Timer Recording (contOd) 35
Use the Number buttons (1-8) to select a slot in
which to store the timer recording. There are eight
4
slots. Numbers for open slots will flash on the screen.4-7
NOTE:If you enter a number for a slot that has already beenPOWER
MARKER
used to store a timer recording,PREVIOUSLYSETPROGRAM will
appear on the screen briefly.Information about the program inSETUPAUDIO SUBTITLEANGLE
that slot will appear on the screen.If this happens,press DIS-REC/OTRREPEATREPEAT
A-B
PLAY/STATUS/EXIT,then select another number.
CHANNEL/SKIP
CLEAR
TITLEMODERETURN
Use the Number buttons to enter the TV channel
you want to record.OUTPUT SELECT
5
Cable TV Users,enter channel numbers as a two-digitDVDVCR
DISC
number for the quickest results. For example, to select
MENUOK
channel 6, press 0,6. If you only press the Number 6 but-
ton, channel 6 will be selected after a brief delay.There
also may be a brief delay when you select channels 10, 11,
STOPPLAY
and 12.If you want to select channels 100 and above,
enter channel numbers as a three-digit number. ForREWFF
PAUSEexample, to select channel 117, press 1, 1, 7.
Antenna Users,enter channel numbers as a two-digitTIMER SET
number for the quickest results. For example, to select123
VCR/TV
channel 5, press 0,5. If you only press the Number 5 but-
456
ton, channel 5 will be selected after a brief delay.You mayMEMORY
only select channels 2-69.789
SPEED
If you are recording from line input,press 0,0 to select
+100
AV REAR. See Helpful Hints below.SEARCH MODEDISPLAY ZOOMSLOW
If you are using a Cable Box/DBS,select the Cable
TIME SEARCH STATUS/EXIT
Box/DBS output channel (03 or 04). Set the Cable
Box/DBS to the channel you want to record. Leave the
Cable Box/DBS on for the timer recording. Details
are on page nine.
Press two Number buttons for the hour you want
the recording to begin. Press two Number buttons
6
for the minute you want the recording to begin.
Press 1 for AM or 2 for PM. For example, for 9:30 PM,
press 09, 30, 2.
ONE TIME PROGRAM
PROGRAM1
CHANNEL10
TIME ON� � :� �
Helpful Hints
TO CORRECT PUSH CLEAR
Y Entries that do not match the
TO END PUSH EXIT
DVD/VCROs clock or calendar will
cause a question mark to appear
Follow the instructions in step 6 to enter the record-on the screen.
ingOs stop time. (AM or PM will be set automatically.)Y If you are recording from line input,
7
connect the audio and video cables
ONE TIME PROGRAM
PROGRAM1to the AUDIO IN and VIDEO IN
CHANNEL10
TIME ON09:30 PMjacks on the back of the DVD/VCR.
TIME OFF� � :� �
(Please see illustration on page 38.)
Y The +10 Number button has no
TO CORRECT PUSH CLEAR
TO END PUSH EXITeffect in VCR mode,so do not use it
to enter TV channel numbers at
step 5.
Instructions continue on page 36. |
ACEC
