Before requesting service
EnglishIf it appears that the DVD-Video player is faulty, first consult
this checklist. It may be that something has been overlooked. Under no
circumstances attempt to repair the system yourself; this will invalidate
the warranty.
Look for the specific symptom(s).Then perform only the actions listed
to remedy the specific symptom(s).
SymptomRemedy
No powerCheck if both plugs of the mains cord are properly connected.
Check if there is power at the AC outlet by plugging in another appliance.
No pictureCheck if the TV is switched on.
Check the video connection.
Distorted pictureCheck the disc for fingerprints and clean with a soft cloth, wiping from
centre to edge.
Sometimes a small amount of picture distortion may appear .This is not
a malfunction.
Completely distorted picture with player menu NTSC/PAL switch in wrong status, hold down the STOP button
and press the NEXT button.
No colour in picture with player menuNTSC/PAL switch in wrong status, hold down the STOP button
and press the NEXT button.
Disc canOt be playedEnsure the disc label is upwards.
Clean the disc.
Check if the disc is defective by trying another disc.
No soundCheck audio connections.
If using a HiFi amplifier, try another sound source.
Distorted sound from HiFi amplifierCheck to make sure that no audio connections are made to amplifier
phono input.
No return to start-up screen when
disc is removedReset by switching the player off, then on again.
Check to see if the program requires another disc to be loaded.
The player does not respond to
the remote controlAim the remote control directly at the sensor on the front of the player
Avoid all obstacles which may interfere with the signal path.
Inspect or replace the batteries.
Distorted or B/W picture with DVD or
Video CD discThe disc format is not according to the TV-set used (PAL/NTSC)
No audio at digital outputCheck the digital connections
Check the settings menu to make sure that the digital output is set to on.
Check if the audio format of the selected audio language matches your
receiver capabilities.
Buttons do not workSet the player in standby by using the STANDBY button on the front
of the player. Press standby again to set the player back to ON.
Player does not respond to all operating
commands during playbackOperations are not permitted by the disc. Refer to the instructions in
the disc inlay.
32 BEFORE REQUESTING SERVICE |
ACEC
