BEFORE REQUESTING SERVICE
DISTORTED SOUND FROM HIFI AMPLIFIER ......................
BEFORE REQUESTING SERVICE
Y Check to make sure that no audio connections
If it appears that the DVD-Video player is faulty, first consultare made to the amplifier phono input.
this checklist. It may be that something simple has been
overlooked. Under no circumstances should you try toNO RETURN TO START-UP SCREEN WHEN DISC IS
repair the player yourself; as this will invalidate theREMOVED..................................................................................
warranty. Only qualified service personnel can removeY Reset by switching the player off, then on
the cover or service this player.again.
Look for the specific symptom(s). Then perform only theY Check to see if the program requires another
actions listed to remedy the specific symptom(s).disc to be loaded.
THE PLAYER DOES NOT RESPOND TO THE REMOTE
SYMPTOMCONTROL ..................................................................................
Y RemedyY Aim the remote control directly at the sensor on
the front of the player
NO POWER................................................................................
Y Avoid all obstacles which may interfere with
Y Check if the on/off button on the front of thethe signal path.
player is set to on.Y Inspect or replace the batteries.
Y Check if both plugs of the mains cord are pro-
perly connected.DISTORTED OR B/W PICTURE WITH DVD OR VIDEO CD
Y Check if there is power at the AC outlet byDISC ..........................................................................................
plugging in another appliance.Y The disc format is not according to the TV-set
NO PICTURE..............................................................................used (PAL/NTSC)
Y Check if the TV is switched on.NO AUDIO AT DIGITAL OUTPUT ..........................................
Y Select the same channel and source on the TV
as on the player.Y check the digital connections
Y Check the settings menu to make sure that the
Y Check the video connection.digital output is set to on.
DISTORTED PICTURE..............................................................Y Check if the audio format of the selected audio
Y Check the disc for fingerprints and clean with alanguage matches your receiver capabilities.
soft cloth, wiping from centre to edge.BUTTONS DO NOT WORK......................................................
Y Sometimes a small amount of picture distortion
may appear .This is not a malfunction.Y Turn the player off and on with the power
COMPLETELY DISTORTED PICTURE/VERTICAL ROLL ........on/off button on the front of the player.
Y If the picture is distorted completely or if theDELAYED PLAY WHEN SWITCHING DISK..........................
picture rolls vertically, make sure the NTSC/PALY If play delays more than one minute (OReading�
setting at the DVD player matches the videodisplayed on TV screen), the player did not com-
signal of your television.
Y If your TV video signal is NTSC, select the NTSCplete its disk eject cycle.
setting at the DVD player. Y Push the STOP button to stop the playback, then
Y If your video signal is PAL, select the PAL set-wait for the Oeject disk� display on the TV
Screen before pushing the tray OPEN/CLOSE
ting.- see GETTING STARTED, NTSC/PAL SET-button.
TING
NO COLOUR IN PICTURE ......................................................Y The new disk should play within 10 seconds.
Y The disc format does not match the video signalCLEANING DISCS
of your TV (PAL/NTSC)
Some problems occur because the disc inside the player
DISC CANOT BE PLAYED ........................................................is dirty. To avoid these problems clean your discs regularly, in
Y Ensure the disc label is upwards.the following way:
Y Clean the disc.Y When a disc becomes dirty, clean
Y Check if the disc is defective by trying anotherit with a cleaning cloth. Wipe the
disc.disc from the centre out.
NO SOUND................................................................................
Y Check audio connections.CAUTION
Y If using a HiFi amplifier, try another sound sour-Do not use solvents such as
ce.
Y Check the Digital Output menu is selected tobenzine, thinner, commercially
ALL if a DTS disc is played.available cleaners, or anti-static
Y Ensure there is a DTS decoder connected whenspray intended for analog discs.
selecting DTS.
24eenngglliisshh |
ACEC
