Before Requesting Service
If it appears that the DVD Video player is faulty, first consult this
checklist. Something may have been overlooked. Under no
circumstances should you attempt to repair the system yourself;
Englishthis will invalidate the warranty.
Look for the specific symptom(s). Then perform only the actions
listed to remedy the specific symptom(s).
SymptomRemedy
No power� Make sure the power cord is properly connected.
� Check if there is power at the AC outlet by plugging in another appliance.
No sound� Check audio connections.
� If you are using a HiFi amplifier, try another sound source.
� DTS-CD do not play on the SACD player.
Distorted sound from HiFi amplifier� Check to make sure that no audio connections are made to the amplifierOs
phono input.
Disc canOt be played� Ensure the disc label is facing up.
� Clean the disc.
� Check if the disc is defective by trying another disc.
No picture� Check if the TV is switched on.
� Check the video connection.
� Check if Audio Direct is turned off (only for CD and SACD).
Distorted picture� Check the disc for fingerprints and clean the disc with a soft cloth, wiping
from the center to the edge in a straight line.
� Sometimes a small amount of picture distortion may appear .This is not a
malfunction.
Completely distorted picture� The NTSC/PAL switch may be in the wrong status.
or no Colour with player menu� Press the 9 STOP and T NEXT buttons simultaneously and keep them
pressed while you turn the player ON.
No return to start-up screen when� Reset the unit by switching the player OFF, then ON again.
disc is removed� Check to see if the program requires another disc to be loaded.
The player does not respond to� Aim the remote control directly at the sensor on the front of the player.
the remote control� Remove any obstacles between the player and the remote control.
� Inspect or replace the batteries in the remote control.
Distorted or black/white picture� The disc format does not match your TVOs video signal (PAL/NTSC).
with DVD or Video CD
No audio at digital output� Check the digital connections.
� Check the settings menu to make sure the digital output is set to on.
� Check if the audio format of the selected audio language matches your
receiver capabilities.
Buttons do not work� Reset by switching the player OFF then ON again.
Audible �clicksO from playerOs internal� During operation the relais of the player may be switched, leading to an
audible �clickO. This is not a malfunction.
Player does not respond to some� Operations may not be permitted by the disc. Refer to the instructions of
operating commands duringthe disc.
playback
BEFORE REQUESTING SERVICE31 |
ACEC
