Preparation
� Smart Picture� Digital Crystal Clear (on Pr/Cr Pb/Cb
Y Progressive Scan Video Out only)
? Colour settings (not applicable on
Component Video Output)Digital Crystal Clear (DCC) allows you to
English
You can select one of five predefined sets offine-tune the following parametres on the
progressive scan output.
colour settings and one set (Personal) which you
? Chroma Delay - is where the Chroma
can define yourself.
(colour) and luma (brightness) signals are not
You can also press SMART PICTURE key (on the
front panel) to access the colour settings in thesynchronised. This allows you to adjust the
advance delay of the chroma signal to yield a
menubar.
perfectly clear picture.
? Gamma - allows you to adjust the intensity of
the picture non-linearly. A positive value allows
you to bring out low level detail in dark scenes,
while a negative value will emphasize contrast.
? Sharpness - allows you to adjust sharpness of
the picture.
? DCDi (New Directional Correlation De-
? When Personal is selected it allows you to fine-interlacing) - computes and tracks the angle of
tune saturation, brightness and contrastedge to fill in the missing pixel on the TV screen.
? Use 3 or 4 keys to adjust the values of theseSwitching DCDi ON will optimise the image
parametres. Press OK or 1 to exit.quality significantly, especially during the slow
motion playback.
� TV System (NTSC/PAL Conversion)Aspect Ratio - to adjust the ratio of the pictures
on the TV screen.
Allows you to select between PAL, NTSC and
NO LINEAR STRETCH: for display of 4:3 image
AUTO mode depending on your TV. PlayerOs
on 16:9 TV with non-linear stretching (centre
default setting is set to AUTO.
portion of screen is stretch less than the side).
The conversions supported are as follows:
PILLER BOX: for display of 4:3 image on 16:9 TV
DiscOutput formatwithout stretching.
TypeFormatSelected mode
NTSCPALAUTOOFF: No aspect ration adjustment
DVDNTSCNTSCPALNTSC
Not? True Life - produces a more dynamic picture
PALSupportedPALPAL
by increasing the picture contrast and the colour
VCDNTSCNTSCPALNTSC
intensity.
PALNTSCPALPAL
Note:
1In the Personal Preferences Menu, select TV- DCDi, Aspect Ratio and True Life adjustment
System.are only applicable on Progressive Scan output.
2Press 3 or 4 to select PAL, NTSC or AUTO.
Notes:
- If you have a PAL only TV, ensure that your TV
System setting is PAL.
- AUTO can only be selected when using a TV
that supports both the NTSC and PAL systems
(multisystems).
- This setting is applicable for CVBS output on
cinch and SCART only.
- Slight picture distortions may occur due to this
conversion. This is normal. Thus, the AUTO format
is most suitable for the best picture quality.
17 |
ACEC
