Manually setting the time & date
If the time is incorrect, this could be due to a weak or disrupted TV signal. If this is the case,
switch off the automatic function.
Attention!
If data from the GUIDE PLus+? system were loaded, you can not change the clock/date because
this information was taken from the GUIDE Plus+? system. Therefore you can not select this
function.
Press SYSTEM-MENU on the remote control. The menu bar
will appear.
1
Select 'A' using D or C .
2
Select line 'Installation' using CH- B or ACH+ and confirm
with C .
3
Select line 'Time/Date' using CH- B or ACH+ and confirm
with C .
4
a'Notallowed'will appear on the TV screen
b The time/date will automatically be taken from the EPG information.
Therefore you can not set the time/date manually.Problem
Select 'Manual' with CH- B or ACH+ .
5
Confirm with OK .
6
Change the time in line 'Time' using the number buttons 0..9 onTime/Date
your remote control.Manual
7
Time09:02
Check 'AM/PM', 'Year', 'Month', and 'Date' in the same way.AM/PMAM
To select between the fields, use CH- B or ACH+ .Year2003
8Month01Change the information with D , C or the number buttons
Date01
0..9 .Daylight SavingOff
Select one of the following settings in line 'DaylightSaving':
To exit press
'On': The time set corresponds to the summer time (summer
SYSTEM MENU
9time is on)
'Off': The time set corresponds to the winter time (summer time
is off)
When all settings are correct, confirm with OK .
10
To end, press SYSTEM-MENU .
11
If the setting has been confirmed with OK the automatic system is disabled.
32
Installing your DVD Recorder |
ACEC
