Satellite receiver
If you are connecting a satellite receiver, please read the section on 'Using a
satellite receiver'.
Decoder
If you are connecting a decoder, you must install it as described in the next
Tip
section.
Using a satellite receiver
TV channels from a satellite receiver (connected to scart socket EXT 2 AUX I/O ) are received
on the DVD recorder on programme number 'EXT2'
If necessary, use the MONITOR button to switch to the internal tuner.
Then select programme number 'EXT1' with 0 on the remote control and programme number
'EXT2' with CHANNEL r .
You should select the TV channels to be received by the satellite receiver directly on the
receiver itself.
Allocating a decoder
Some TV channels send coded TV signals that can only be viewed properly with a purchased or
rented decoder. You can connect such a decoder (descrambler) to your DVD recorder. The
following function automatically activates the connected decoder for the TV channel you want to
watch.
How do I allocate the decoder for EasyLink?
If your TV set supports 'Easy Link' the decoder must be assigned to the
relevant TV channel on the TV set (see the operating instructions for your TV
set). Settings cannot then be made in this menu.?
1Switch on the TV set. If required, select the programme number for
the DVD recorder.
2Switch on the DVD recorder using STANDBY/ON .
3Use the CHANNEL q and CHANNEL r buttons on the DVD
recorder or the number buttons 0..9 on the remote control to select
the TV channel for which you want to use the decoder. If necessary,
use the MONITOR button to switch to the internal tuner.
4Press the SYSTEM-MENU button on the remote control. The menu
bar will appear at the top of the screen.
5Select 'A' using D or C .
6Select line 'Installation' using B or A and confirm with C .
24
Installing your DVD recorder |
ACEC
