Troubleshooting (continued)
English
Problem (General) Solution
No sound. Check the recorder audio connection. Read chapter Basic
Recorder Connections - Connecting the audio cables for
details.
Set the Analogue output or Digital output correctly, based on
the device you have connected to this recorder. Read chapter
System Menu Options - Audio Output settings for details.
No TV signal received from Have your aerial or cable TV signal checked.
the recorder. Install the TV channel. Read chapter System Menu Options -
Analogue Channel settings - Auto Search for details.
The message Disc contains This message may appear if you insert a disc that was not
unknown data appears.
cause problems during recording. To use the disc again, do the
following :
1) Make sure that the surface of the disc is clean.
2) Press OPEN/CLOSE on this recorder to open the disc tray.
3) Insert the disc but do not close the tray.
4) Hold down button number {5} on the remote control until
the tray closes. This recorder will start the repair process.
5) If the disc is recovered, the Picture Index screen will appear.
Please observe the following:
Error during recording : The title may be missing.
Error while changing the title/index picture: The original title/
index picture may be visible.
Error while
The message NO SIGNAL Check that the cable is plugged in
appears. If a recording is made from a video recorder, change the
tracking on the video recorder.
This recorder may not be able to recognise the video input
signal if this signal is poor or does not comply with relevant
standards.
X appears at the bottom of No aerial signal received for the current channel or no video
the TV screen.signal received from the external input channel (EXT1, EXT2,
CAM1 or CAM2).
Check the antenna connection.
Check the connection and turn on the connected device.
92 |
ACEC
