Getting Started
Step 1 : Inserting BatteriesStep 2 : Finding your viewing
channel
A Press STANDBY-ON 2 on the DVD
player to turn it on.
B Turn on the TV and set it to the correct
video-in channel. You should see the blue
DVD background screen.
� Usually these channel are between the
A Open the battery compartment.lowest and highest channels and may
B Insert two batteries type R03 or AAA, be called FRONT, A/V IN, VIDEO.
following the indications (+ ) inside the See your TVs manual for more
compartment.details.
� Or, you may go to channel 1 on your
C Close the cover.TV, then press the Channel down
CAUTION!button repeatedly until you see the
Remove batteries if they areVideo In channel.
� Or, the TV remote control may have
exhausted or if the remote is not to
a button or turn that chooses
be used for a long time.
different video modes.
Do not use old and new or
different types of batteries in� Or, set the TV to channel 3 or 4 if
combination.you are using an RF modulator.
Batteries contain chemical
C If you are using external equipment, (such
substances, so they should be
as audio system or receiver), turn it on
disposed of properly.and select the appropriate input source
for the DVD player output. Refer to the
Using the remote control to
equipment users manual for detail.
operate the system
MENUDISCDISPLAY
RETURNTITLESETUP
PREVPLAY/PAUSENEXT
STOPMUTE
A Aim the remote control directly at the
remote sensor (IR) on the front panel.
B Do not put any objects between the
remote control and the DVD player
while operating the DVD player.
16
001-47_dvp3110K_75_eng.indd 161-47_dvp3110K_75_eng.indd 1622007-02-09 2:44:54 PM007-02-09 2:44:54 PM |
ACEC
