Getting Started
EnglishStep 2: Setting up the TV
Step 1: Inserting batteries into
the Remote Control
IMPORTANT!
3Make sure you have completed all
the necessary connections. (See
1pages 8-9 OConnecting TV�).
21Turn on the TV and set to the correct
video-in channel. You should see the blue
Philips DVD background screen on the
1Open the battery compartment.TV.
� Usually these channels are between the
2Insert two batteries type R06 or AA,lowest and highest channels and may be
following the indications (+-) inside
the compartment.called FRONT, A/V IN, or VIDEO. See your
TV manual for more details.
3Close the cover.� Or, you may go to channel 1 on your
TV, then press the Channel down button
repeatedly until you see the Video In
Using the Remote Control tochannel.
operate the Player� Or, the TV Remote Control may have a
1Aim the Remote Controlbutton or switch that chooses different
STOPdirectly at the remotevideo modes.
sensor (IR) on the front� Or, set the TV to channel 3 or 4 if you
panel.are using an RF modulator.
2Do not put any objects2If you are using external equipment, (eg.
between the Remoteaudio system or receiver), turn it on and
Control and the DVDselect the appropriate input source for
Player while operating thethe DVD Player output. Refer to the
DVD Player.equipment ownerOs manual for detail.
CAUTION!PREVIEWPREVIEW MUTEMUTE
� Remove batteries if they are
exhausted or if the Remote Control
is not being used for a long time.
� Do not use old and new or
different types of batteries in
combination.
� Batteries contain chemical
substances, so they should be
disposed properly.
14
01-32 DVP530_781417/03/2004, 3:48 PM8239 300 30442 |
ACEC
