Getting Started
Step 1: Inserting batteries intoStep 2: Setting up the TV
the Remote Control
IMPORTANT!
Make sure you have completed allEnglish
3the necessary connections. (See
1pages 9-11 OConnecting TV�).
21Turn on the TV and set to the correct
video-in channel. You should see the
Philips DVD background screen on the
1Open the battery compartment.TV.
2Insert two batteries type R06 or AA,2Usually these channels are between the
following the indications (+-) insidelowest and highest channels and may be
the compartment.called FRONT, A/V IN, or VIDEO. See your
TV manual for more details.
3Close the cover.� Or, you may go to channel 1 on your
TV, then press the Channel down button
repeatedly until you see the Video In
Using the Remote Control tochannel.
operate the Player� Or, the TV Remote Control may have a
1Aim the Remote Controlbutton or switch that chooses different
directly at the remoteIRvideo modes.
sensor (iR) on the front� Or, set the TV to channel 3 or 4 if you
panel.are using an RF modulator.
2Do not put any objects3If you are using external equipment, (eg.
between the Remoteaudio system or receiver), turn it on and
Control and the DVDselect the appropriate input source for
the DVD Player output. Refer to the
Player while operating the
DVD Player.equipment ownerOs manual for detail.
To deactivate Progressive manually
The progressive scan display present 60
complete frames per seconds, rather than
PREVIEW MUTE30 frames per second of interlaced
CAUTION!DIMSLEEP SOUNDSURROUND
� Remove batteries if they arescanning (ordinary normal TV system).
With nearly double the number of line,
exhausted or if the Remote Controlprogressive scan offers higher picture
is not being used for a long time.
� Do not use old and new orresolution and eliminates bothersome
motion artifacts those jagged edge on
different types of batteries inmoving objects.
combination.
� Batteries contain chemical
To enjoy the full quality potential offered
substances, so they should beby progressive scan feature, a progressive
disposed properly.
scan TV is required. To activate
progressive function, refer to �Progressive
- turning on/offO on page 32.
15 |
ACEC
