6ENGLISH
This turbo nozzle has been especially designed5 Move the turbo nozzle slowly forward and
for optimum cleaning of rugs and carpets withbackward over the carpet.
poles of max. 1.5 cm.
6 Near fringe edges only move the turbo
The rotating brush effortlessly picks up smallnozzle in the direction of the arrow
threads, hairs, fluff and more difficult to vacuum(fig. 4).
particles.Otherwise the fringes may be wound around
Good in-depth cleaning is guaranteed with thethe brush roller.
turbo nozzle.
Cleaning
For hard floors (parquet, tiles, etc.) you can also
use this turbo nozzle.It may happen that your turbo nozzle comes
stuck or becomes less effective.
For large surfaces, however, we advise you toThis may be caused by clogged hairs and
use the nozzle provided with your vacuumthreads around the brush roller or because the
cleaner.turbine has become blocked.
� Always remove the mains plug from the
Important
wall socket first.
� It is not advisable to use the turbo nozzle
- on very deep-pole carpets Cleaning the brush roller
(deeper than 1.5 cm);
- for vacuuming large objects (e.g. paper clips,1 Insert the points of a pair of scissors into
buttons, nails);the brush roller slot (fig. 5).
- on wet floors.2 Move the scissors to catch the threads or
� Never leave children and/or animals
unattended while the turbo nozzle ishairs in the scissors.
active.3 Cut the threads or hairs and remove them
Touching the rotating brush may cause injury.manually or using a small-sized pair of
pliers.
� Before cleaning the turbo nozzle always
remove the mains plug from the wallCleaning the turbine
socket.
� When using the turbo nozzle always apply
maximum suction power from yourIf cleaning the brush roller was not enough,
vacuum cleaner.open the turbo nozzle and clean the inside:
1 Unscrew the four screws on the bottom
How to useside (fig. 6).
1 Remove the normal nozzle from your2 Turn the turbo nozzle over and remove
vacuum cleaner and place the turbothe cover (fig. 7).
nozzle. For reliable connection rotate the
tube a little to the left and to the right3 Clean the turbine or other parts (fig. 8).
while inserting (fig. 1).4 Reassemble the turbo nozzle in reverse
order.
2 Insert the mains plug into the wall socketEnsure that the two sections fit perfectly.
and (if your vacuum cleaner has electronic
suction power control) select maximum
suction power.
Ensure that the slide on the hand grip is closed.
� On the turbo nozzle you can see a slide
for adjustment to the type of carpet.
3 For smooth carpet or hard floors: to the
left (fig. 2).
4 For deep-pile carpet: to the right (fig. 3). |
ACEC
