Accessory holderMake sure the - and + poles are pointing in the
1 The accessory holder can simply be snappedright direction.
onto the handgrip. (fig.12)� With the infrared remote control you can set
� There are two ways to store accessories inthe suction power to one of 5 different
suction power settings.When you switch the
the accessory holder.appliance on, it will always start running at the
� The crevice tool and small nozzle can behighest suction power setting.
stored in the accessory holder by pushing
them into the holder.To detach them, pull2 By pushing the - button, you will reduce the
them out of the holder.(fig.13)suction power by one setting.(fig.19)
Please note the way in which the small nozzle
must be placed in the accessory holder.3 By pushing the + button, you will increase the
suction power by one setting.
� Instead of the small nozzle, the small brush
can be stored in the accessory holder by4 Push the standby button to temporarily
switch the vacuum cleaner off, for instance
pushing it into the holder.(fig.14)when you have to move some furniture.
Animal brush (specific types only)5 To continue vacuum cleaning, simply press the
- button or the + button.The appliance will
While combing your dog or cat with the Animalstart operating at the previously selected
Brush, dirt, loose hairs and knots will be removed.suction power setting again.
Regular combing will keep the fur healthy.
1 Connect the animal brush to the handgripParking the tube
('click').(fig.15)1 By inserting the ridge on the nozzle in the
2 Place the vacuum cleaner as far away fromparking slot, you can park the tube in a
the dog or cat as possible. Set the suctionconvenient position.(fig.20)
power to the lowest setting.
Storing the vacuum cleaner
3 For optimal results, move the brush through
the fur of the cat or dog in one direction.1 You can put the appliance in upright position
4 You can remove hairs from the Animal Brushand attach the nozzle to the appliance by
inserting the ridge on the nozzle in the
by detaching it from the appliance andslot.(fig.21)
vacuum cleaning it.(fig.16)
Vacuum cleaningReplacing the dustbag
1 Replace the dustbag as soon as the dustbag-
Adjusting suction powerfull indicator changes colour. (fig.22)
� You can adjust the suction power whileThe dustbag is full when the colour of the
vacuum cleaning.indicator has changed even when the nozzle is
1 Use the slide control on top of thenot placed on the floor.
appliance.(fig.17)
2 Use maximum suction power for vacuum2 Switch the appliance off.
cleaning very dirty carpets and hard floors.3 Open the cover by pulling it upwards.(fig.23)
3 Use minimum power for vacuum cleaningPlace you fingers at the inlet of the cover and
curtains, table carpets, etc.press with your thumb on the ridge on top of the
cover.
Infrared remote control (specific types4 Lift the dustbag holder out of the
only)appliance.(fig.24)
1 Place the batteries in the batteryMake sure you hold the dustbag upright when
compartment.(fig.18)lifting it out of the appliance.
7 |
ACEC
