SOURCE SELECTION
SOURCE SELECTUsing one source selection for two or more
When selecting a source by turning SOURCE SELECT, theappliances
You may assign more than one source to a source selection.Englishaudio and video inputs with the corresponding name are
activated. The incoming signal is reproduced by all audio andThis can be useful when products are connected one after the
� if the source includes a video signal � video outputs of theother in a chain.
receiver. It is possible to reassign a source selection to other
than these standard inputs.Example: A VCR is connected to the TV but only the TV is
connected to the receiver. Both SOURCE SELECT
Source selected........Connectors usedsettings, TV as well as VCR, have to use the TV
DVD...............................COAX 1 digital audio input and input connectors.
DVD IN video input
PHONO..........................PHONO IN audio input1 Choose * SELECT INPUT from the menu and press
NEXT 2.
TUNER ..........................The tuner part of the receiver is used,
all inputs are switched off.
2 Turn SOURCE SELECT to select the source which should be
CD.................................CD IN audio inputreassigned (e. g. VCR).
CDR/TAPE.....................CDR/TAPE IN audio inputyThe name of the source is displayed and the light of the
TV..................................TV IN audio input and source flashes.
no video input
VCR...............................VCR IN audio input and 3 Turn X MENU NAVIGATOR to select the input connectors
which should be used (e. g. VCR -> TV IN).
VCR IN video input
SAT ...............................SAT IN audio input and 4 Press ENTER / OK to confirm your selection.
SAT IN video inputySTORED is displayed briefly.
5 This source selection is now using the chosen audio input (e.
g. VCR uses the TV IN input connectors, VCR <TV IN> is6 CHANNEL-DVD/SACD INPUT selection
The 6 CHANNEL / DVD INPUT connectors can be assigned to
displayed briefly when switching to VCR).
any of the available sources (excluding TUNER and PHONO).
The assignment can be done via the * SELECT INPUT
About 6 CHANNEL-DVD/SACD INPUT
option in the menu. See below for more details.
The 6 CHANNEL / DVD INPUT can be used to connect a
device with a built-in multichannel decoder (e.g. Dolby Digital,
DTS, etc.) and 6-channel output connector, i. e. a high endReassigning a source selection
If a source is selected with SOURCE SELECT the standard
DVD/SACD player.
audio input is used. To change this, the source selection must
be reassigned to another audio input.
When using the 6 CHANNEL / DVD INPUT audio input, the
receiver works as a multichannel amplifier. The source
Example: Reassigning CD from the analog CD IN audio inputreproduces surround sound and sends it to the receiver
to the digital COAX 2 IN audio input.
divided into the necessary channels. Therefore the
SURROUND ON/OFF, HALL and SURR. MODE button have no
1 Choose * SELECT INPUT from the menu and press
NEXT 2.effect since the provided signal is already multichannel.
From a source which is connected to the
2 Turn SOURCE SELECT to select the source which should be
6 CHANNEL / DVD INPUT audio input cannot be recorded.
reassigned (e. g. CD).
yThe name of the source is displayed and the light of the
source flashes.
3 Turn X MENU NAVIGATOR to select the input connectors
which should be used (e. g. CD -> COAX2).
4 Press ENTER / OK to confirm your selection.
ySTORED is displayed briefly.
5 This source selection is now using the chosen audio input
(e. g. CD uses the COAX 2 IN input connectors, COAX2
lights when switching to CD).
19 |
ACEC
