Radio Reception
Note:Erasing a preset radio station
� If no preset number is selected, automatic preset
will begin from preset (1) and all your former1Press à or ë to select the preset radio station
presets will be overridden.Englishto be erased.
2Press and hold �on the system until
Manual Preset ProgrammingOPRESET DELETED� is displayed.
� The deleted radio frequency remains on the
1Tune to your desired radio station (refer to
Tuning to radio stations).display.
� The preset numbers of all other preset radio
2Press PROG.
stations in the band with higher numbers are
�PROG starts flashing.also decreased by one.
� The next available preset number is displayed
Repeat steps 1�2 to erase other preset radio
for selection.
stations.
To store the radio station to another
preset numberChanging tuning grid (not available for
Press à or ë to select the desired preset
all versions)
number.
In North and South America, the frequency step
3Press PROG again to store the radio station.between adjacent channels in the MW band is
�PROG disappears.
10 kHz (9 kHz in some areas). The preset
Repeat steps 1�3 to store other radio stations.frequency step in the factory is 9 kHz.
Changing the tuning grid will erase all
To exit manual preset modepreviously stored preset radio stations.
Press � on the system.
1Disconnect the system from the AC power
Notes:
supply (pull out the AC power cord).
� If you attempt to store more than 40 preset
radio stations, "FULL" is displayed.2While holding down TUNER and á on the
� During programming, if no key is pressed withinsystem, reconnect the system to the AC power
20 seconds, the system will exit the programmesupply.
mode automatically.� The display will show "GRID 9" or
"GRID 10".
Tuning to preset radio stationsNotes:
Once youve programmed the radio stations,� GRID 9 and GRID 10 indicate that the tuning
press à or ë to select the desired presetgrid is in step of 9 kHz and 10 kHz respectively.
number.� The FM tuning grid also will be changed from
� The preset number, radio frequency, and50 kHz to 100 kHz or vice versa.
waveband are displayed.
For Recording, please refer to OTape
Operation/Recording�.
19
pg 001-029/C355/21-Eng1912/24/01, 11:17 AM3139 115 21381 |
ACEC
