Clock/Timer
2Press CD 1/2/3, TUNER, TAPE orDeactivating the timer
PROGRAM to select the desired source.
� OCD1 [or 2, 3] XX:XX" indicates the CD1Press and hold CLOCKYTIMER for more than
mode is selected.Englishtwo seconds.
� OTU XX:XX� indicates the Tuner mode is2Press � on the system to cancel the timer.
selected.� "CANCEL" is displayed and the disappears.
� OTA1 [or 2] XX:XX� indicates the Tape
mode is selected.Activating the timer (for the same preset
� OPROG XX:XX" indicates the CD programmetime and source)
mode is selected.
1Press and hold CLOCKYTIMER for more than
Before setting timer, make sure the music sourcetwo seconds.
has been prepared.
CD 1/2/3 Load the disc(s). To start from a2Press CLOCKYTIMER again to store.
specific track, make a program (refer to CD� The last set timer information is displayed for
Operation - Programming the disc tracks).a few seconds and is shown.
TUNER tune to the desired radio station.
TAPE load the prerecorded tape into tapeSleep timer setting
deck.The sleep timer enables the system to switch to
3Pressa or á on the system repeatedly to setstandby mode automatically at a preset time.
the hour for the timer to start.1Press SLEEP repeatedly to select a preset time.
4Pressà or ë on the system repeatedly to set� The selections are as follows (time in
the minute for the timer to start.minutes):
5Press CLOCKYTIMER to store the timer.15 " 30 " 45 " 60 " 90 " 120 "
� "TIMER ON" is displayed, followed by the setOFF " 15
timer "XX:XX" and the selected source.� "SLEEP XX" or "OFF" is displayed. "XX" is the
� remains on the display.time in minutes.
2When you reach the desired length of time, stop
At the preset time, the selected sound source
will play.pressing the SLEEP button.
� is shown, except for "OFF" mode.
To exit without storing the setting� The sleep timer is now set. Before the system
Press �on the system.switches to standby mode, a countdown of 10
seconds is displayed.
"SLEEP 10" " "SLEEP 9".... " "SLEEP 1"
Notes:
� When the preset time is reached and the" "SLEEP"
selected disc tray is empty, the next available disc
will be selected. If all the disc trays are not
available, Tuner will be selected automatically.
� During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
25
pg 001-029/C355/21-Eng2512/24/01, 11:18 AM3139 115 21381 |
ACEC
