TROUBLESHOOTING
EnglishWarning! Under no circumstances should you tryTape Deck OperationLack of bass sound or apparently imprecise
to repair the system yourself, as this will invalidatephysical location of musical instruments.
ORECORDING ACTIVE� is displayed.
the warranty.Y Speakers are connected wrongly.
Y A recording is in progress."Check the speaker connection for proper phasing, red/
Y If a fault occurs, check the points listed below before"Stop the recording or wait until it is finished.
black wires to red/black terminals.
taking the system for repair.OTAPE DUBBING ONLY� is displayed.
Y Should any problems persist after you have madeRemote control has no effect on the system.
Y Tape dubbing is only possible in tape mode.
these checks, consult your nearest dealer or service"Switch source to tape mode.Y The distance to the system is too large.
center."Reduce the distance.
Recording or playback cannot be made or there is aY Batteries are inserted incorrectly.
CD Player Operation"Insert the batteries with their polarities (+/� signs) as
decrease in audio level.
ONO DISC� is displayed.indicated..
Y The disc is inserted upside down.Y Dirty tape heads, capstans or pressure rollers.Y Batteries are exhausted.
"See section on tape deck maintenance.
"Place CD with printed side up."Replace the batteries.
Y Magnetic build-up in the record/playback head.
Y Moisture condensation at the lens."Use demagnetizing tape.Y Wrong source is selected.
"Wait until lens has adjusted to normal room"Select the source (CD, TUNER, etc.) before pressing
temperature.Generalthe function button, (PLAY, PREV/NEXT, etc.).
Y There is no disc in the CD tray.
System does not react when any button is pressed.Timer not working.
"Insert a CD.Y Electrostatic discharge.Y Timer is not switched on.
Y The CD is dirty, badly scratched or warped.
"Press STANDBY-ON to switch the system off. Remove"Press CLOCKYTIMER to switch on the timer.
"Clean or replace the CD.
the AC power plug from the wall outlet, thenY Dubbing/recording is in progress.
Y The CD lens is dirty or dustyreconnect and switch on the system again."Stop dubbing/recording.
"See section under Maintenance.
No or poor sound.System displays features automatically; buttons
Radio ReceptionY Volume is not turned up.flash continuously.
Y Demonstration mode is switched on.
Poor radio reception"Adjust VOLUME.
Y The signal strength is too weak.Y The headphones are connected."Press and hold STOP � for 3 seconds to switch off
the demonstration.
"Adjust the antenna."Disconnect the headphones.
Y The TV or VCR is too close to the stereo system.Y Speakers are not connected or are connected wrongly.
"Separate the stereo system from the TV or VCR."Check that the speakers are connected correctly.
"Connect an external antenna for better reception."Make sure that the stripped speaker wire is clamped.
Reversed left and right sound.
Y Speakers are connected wrongly.
"Check the speaker connections and location.
24
3139 116 17942Untitled-26246/15/00, 4:52 PM |
ACEC
