TROUBLESHOOTING
Warning! Under no circumstancesY The CD is badly scratched or dirty.No or poor sound.Y Batteries are exhausted.
you should try to repair the set yourselfaReplace or clean CD.Y Volume is not turned up.aReplace the batteries.
English
as this will invalidate the guarantee.aAdjust VOLUME.
Timer not working.
Do not open the set as there is a risk ofY The headphones are connected.
Radio ReceptionY Clock is not set.
electric shock.aDisconnect the headphones.
aSet the clock.
Poor radio reception.Y Speakers are not connected or are
Y If a fault occurs, check the points listedY Timer is not switched on.
Y The signal is too weak.
connected wrongly.
below before taking the system foraPress CLOCK/TIMER to switch on the
aAdjust the antenna.aCheck that the speakers are connected
repair.timer.
aConnect an external antenna for bettercorrectly.
Y Should any problems persist after youY Dubbing/recording is in progress.
reception.
aMake sure the stripped speaker wire is
have made these checks, consult youraStop dubbing/recording.
Y The TV or VCR is too close to the stereoclamped.
nearest dealer or service center.
system.Clock setting is erased.
aSeparate the stereo system from the TVY There was a power failure.Reversed left and right sound.
CD Player Operationor VCR.aReset the clock.Y Speakers are connected wrongly.
aCheck the speaker connections and
ONO DISC� is displayed.
location.System displays features
Y The disc is inserted upside down.Tape Deck Operation
automatically; buttons flash
Lack of bass sound or apparently
aPlace CD with printed side up.
Recording or playback cannot occur orcontinuously.imprecise physical location of musical
Y Moisture condensation at the lens.
there is a decrease in audio level.Y Demonstration mode is switched on.
aWait until lens has adjusted to normalinstruments.
Y Dirty tape heads, capstans or pressureaPress and hold ? (on the system only)
Y Speakers are connected wrongly.
room temperature.
rollers.for five seconds to switch off theaCheck the speaker connection for
Y There is no disc in the CD tray.
aSee section on tape deck maintenance.demonstration.
aInsert a CD.proper phasing, red/black wires to red/
Y Magnetic build-up in the record/
black terminals.
Y The CD is dirty, badly scratched orA howling sound at external source.
playback head.
warped.Y You hear feedback when you areRemote control has no effect on the
aUse demagnetizing tape.
aClean or replace the CD.listening and recording from the samesystem.
Y The CD lens is dirty or dusty.source simultaneously.Y Wrong source is selected.
aSee section under Maintenance.GeneralaPress AUX to select CDR mode.aSelect the source (CD, TUNER, etc.)
System does not react when any buttonbefore pressing the function button,
ODISC NOT FINALIZED� isAll lighted buttons are not lit.
displayed.is pressed.(PLAY, PREV/NEXT, etc.).Y Equalizer Display is switched on in NITE
Y The CD-RW or CD-R disc is not properlyY Electrostatic discharge.Y The distance to the system is too large.mode.
aPress STANDBY-ON to switch theaReduce the distance.
recorded for the use of a standard CDaRotate JOG to other Equalizer Display.
player.system off. Remove the AC power plugY Batteries are inserted incorrectly.
aRead the instruction booklet of your CD-from the wall outlet, then reconnect theaInsert the batteries with their polarities
power plug and switch on the system(+/� signs) as indicated.
Rewritable or CD-Recorder on how to
finalize a recording.27again. |
ACEC
