Tuner
EnglishNotes:Tuning to Preset Radio Stations
� You can cancel the automatic programming by
pressing PROGRAM or � (on the system only).? Press 4 or 3 to select the desired preset
� If you want to reserve a section of presetnumber.
numbers, for example preset numbers 1 to 9,� The preset number, radio frequency, and
waveband appear on the display.
select preset 10 before starting automatic
programming, only the preset numbers 10 to 40
will be programmed.Changing the MW tuning grid (not
available for version /30)
Manual programming
1Press TUNER (BAND).The frequency step can be changed if necessary.
In North and South America, the frequency step
2Press TUNER (BAND) again to select thebetween adjacent channels in the MW band is
desired waveband : FM or MW.10 kHz. In other parts of the world, it is 9 kHz.
3Press PROGRAM for less than one second.The frequency step preset in the factory is
� The PROG flag starts flashing.
� The next available preset number will be9 KHz.
displayed for selection.For MW Band
4Press a or á to tune to the desired frequency.To change from 9 kHz to 10 kHz or vice
? If you wish to store the radio station to anotherversa
preset number, press 4 or 3 to select theChanging of tuning grid will erase all
desired preset number.previously stored preset stations.
5Press PROGRAM again.
� The PROG flag disappears and the radio1Disconnect the system from the AC power
station will be stored.supply (pull out the AC power cord).
2Press and hold TUNER and TUNING á
? Repeat steps 3 � 5 to store other preset radio
stations.while reconnecting the system to the AC power
supply.
Notes:� Display will show OGRID 10� or OGRID 9.
� When 40 radio stations are stored and you
attempt to store another radio station, the displayNotes:
will show "FULL�. If you want to change an� GRID 9 indicates that the tuning grid is in step
of 9 kHz in MW band. GRID 10 indicates that the
existing preset number, repeat steps 3 � 5.tuning grid is in step of 10 kHz in MW band.
� You can cancel manual programming by� FM tuning grid will also be changed from
pressing � (on the system only).50 kHz to 100 kHz or vice versa.
� During programming, if no button is pressed
within 20 seconds, the system will exit programme
mode automatically.
18
3139 115 20433pg 01-28/C250/21-Eng1829/05/2001, 10:26 AM |
ACEC
