ENGLISH11
4If the temperature light does not go on after you move the
iron, the soleplate still has the right temperature and the iron is
ready for use.
Cleaning and maintenance
Calc-Clean function
� You can use the Calc-Clean function to remove scale and
impurities.
Use the Calc-Clean function once every two weeks. If the water in
your area is very hard (i.e. when flakes come out of the soleplate
during ironing), the Calc-Clean function should be used more
frequently.
1Set the steam control to position O.
2Fill the water tank to the maximum level.
Do not pour vinegar or other descaling agents into the water tank..
3Set the temperature dial to MAX.
4Put the plug in an earthed wall socket.
5Unplug the iron when the temperature light has gone out.
C6Hold the iron over the sink and set the steam control to the
Calc-Clean position (1).The steam control will spring up
slightly.
C7Pull the steam control upwards a little further and gently shake
the iron to and fro.
BSteam and boiling water will come out of the soleplate.Impurities and
scale (if any) will be flushed out.
C8Pull the steam control out of the iron. Use vinegar to remove
scale, if any, from the needle.
Do not bend or damage the steam control needle. |
ACEC
