English
Important
YRead these instructions carefully in conjunction with the illustrations before using the
appliance for the first time.
Keep these instructions for future reference.
YBefore connecting the kettle, check if the voltage indicated on the appliance (underside of
kettle and base unit) corresponds with the mains voltage in your home. If this is not the
case, contact your dealer and do not use the kettle.
YUse the kettle only with the supplied base unit. Do not use the base unit for other purposes.
YIf the mains cord of this appliance is damaged, it must be replaced by the special cord.
Apply to your Philips dealer or the Philips organisation in your country.
YConnect the base unit to an earthed wall socket only.
YThe kettle is protected against damage due to operation with insufficient water by means of
a safety cut-out. This cuts off the power when the heating element gets too hot.
- If the kettle ever is operated with too little or no water, first remove the mains plug from the
wall socket. Leave to cool down for 15 minutes before re-filling with cold water.
The safety cut-out will automatically reset.
YPlace the appliance on a stable flat surface. Ensure that the base unit and the kettle cannot
fall into water and that no water can be splashed onto the base unit.
YNever immerse the kettle or the base unit in water. Do not allow water to penetrate the
electrical parts inside the kettle or the base unit.
YPrevent children from pulling the mains cord or knocking the kettle over.
YThe kettle may be cleaned with a damp cloth. First remove the kettle from the base unit.
The base unit can be cleaned in the same manner. First remove the mains plug from the wall
socket.
If the kettle is tipped too far backwards, water may be spilt through the rear cover. If this
happens the kettle will still be electrically safe. Extra care must be taken if the kettle contains
hot or boiling water.
YDo not place the kettle on a hot surface.
YPour away the very first water boiled with this kettle. The appliance is then ready for use.
General description (fig. 1)unit. Do not pull heavily on the cord to prevent
damage.
A Water gauge- Underneath the base unit there are two
B Lidalternative mains cord exit points. Select the
C On/off switchpoint that will be closest to the wall socket.
D Pilot lightPress the cord firmly into the slot.
E Base unit with cord storage (underside)
F Connector
G "Filterline" scale filter (with type HD 4391How to use the kettle
only)
Filling
- Remove the kettle from the base unit before
Cord storagefilling.
- (Fig. 2a) You can fill the kettle via the spout or...
- The length of the free mains cord from the base- (Fig. 2b) ...after opening the lid. Do not forget to
can be adjusted.close the lid after filling, otherwise the kettle will
For added safety, only the minimum length ofnot automatically switch off after use.
cord should be visible between the base unit
and the wall socket.Do not fill with less than 0.35 litreof water (up to
The mains cord length can be reduced by"MIN" indication) to prevent the kettle running dry
pushing the excess cord back into the basewhile operating.
4 |
ACEC
