EnglisH9
Put the lid on the kettle and turn the lid clockwise until the line on top ofÂ
the kettle is aligned with the line on the lid that indicatesÂ
the close position.Â
4 Place the kettle on its base and put the plug in the wall socket.
, The appliance is now ready for use.
Boiling water
To boil water you, only have to do one thing:
1 Press the on/off button.(Fig. 6)
, The light ring around the on/off button lights up and the 100C
light starts to ash to indicate that the kettle is heating up water to
boiling point 7). (Fig.
, While the water heats the upcur, rent temperature is shown by the
number of lights that The ar 100Ce on. light continues to
ash (Fig. 8).
The kettle brings the water to the boil.
, When the water boils, you hear an audible signal and the kettle
switches off automatically.
, The light around the on/off button goes off and the 100C light
stays on for 120 seconds to let you know the water has just
boiled (Fig. 9).
Note: You can stop the heating process at any time by pressing the on/off
button or removing the kettle from the base. If you remove the kettle from
the base when it is operating, all settings are lost.
setting the water temperature
With the SETTEMP  button on the  ykouettle can heat, up the water toÂ
different temper 100Catures: (boiling  80Cwater), ,60C or 40C.
1 Make sure the kettle Then is emptyll it. with cold water.
To make sure the kettle accurately heats up the water to the setÂ
temperature ll,  the kettle with at least 0.5l water.
Press the TEMPSET button one or more times to set the desired
temperature (Fig.10). |
ACEC
