USING THE FADER START FUNCTION
Starting with the Channel Fader
1 Turn on the fader start switch (CH-1 or CH-2) ofThe following is an example of starting a CD player
the channel connected to the CD player to beconnected to CH-1.
controlled.CH-1
Example:
1010
CH-1
2 Push the channel fader volume control all the8989
77
way to the bottom.OFFON5656
44
33
Fader start switch1212
3 Set the cue point of the CD player and set the00
player to standby at it.
Channel fader volume control
4 When you want to start the player, push up the
channel fader volume control and the CD playerIf cue points have been set in advance when using the
CDJ-100S and CDJ-700S, it is not necessary to leave the
will begin playing.
CD player on standby at the cue point.
If the channel fader volume is returned to its original
Precaution:
position after playing has started, the CD player will
� Channels selected with the cross fader ASSIGN A and
return to the cue point and be on standby.
B switches cannot be started with the channel fader.
Starting with the Cross Fader
1 Turn on the fader start switch (CH-1 or CH-2) of5 Use the cross fader curve selector switch to
the channel connected to the CD player to beselect the cross fader startup curve.
controlled or of the sampler.
6 When the cross fader volume control is slid in
2 Using the cross fader ASSIGN A and B switches,the opposite direction as in O3�, CD player or
select the channel (CH-1 or CH-2) that the CDsampler play will begin.
player is connected to or the sampler.
23
14
THRUSAM-
3 Slide the cross fader volume all the way inPLER
direction opposite the source you want to start.AB
CROSS FADER
In the following example, startup is done with the CDASSIGN A
player connected to CH-1 set to ASSIGN A.
ASSIGN A switchCross fader volume control
Example:
23If cue points have been set in advance when using the
14
THRUSAM-CDJ-100S and CDJ-700S, it is not necessary to leave the
PLER
CD player on standby at the cue point.
AB
CROSS FADERIf the cross fader volume is returned to its original
ASSIGN Aposition after playing has started, the CD player will
ASSIGN A switchCross fader volume controlreturn to the cue point and be on standby.
4 For starting a CD player, set its cue point and set
it to standby at this cue point.
For starting a sampler, select the type of sample
play (SINGLE, LOOP or STRETCH LOOP) with the
effect/sampler selector switch.
When the type of sample play is selected with the effect/
sampler selector switch, the effect/sampler ON/OFF
switch will light green.
23
<DRB1251> |